ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted
Penny

สร้างโดย

Penny

14. ตุลาคม 2026DK
14
0
0
0
0

Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted

A cable of several insulated wires in one bundle, such as the four leads of a strain-gauge bridge. Each copper wire is wrapped in cotton thread and soaked in beeswax, then the wires are twisted together and covered again.
เริ่มต้น
An afternoon

คำแนะนำ

1

Cut the conductors

Cut one copper wire per conductor (four for a bridge), a little longer than the cable.

วัสดุสำหรับขั้นตอนนี้:

ลวดทองแดงลวดทองแดง4 length

เครื่องมือที่ต้องใช้:

คีมปอกสายไฟคีมปอกสายไฟ
2

Wrap each wire in cotton

Clamp one end in the vise and the other in the hand drill's chuck, keeping it taut. Wind cotton thread on in a close spiral with no gaps, then a second layer the opposite way.

วัสดุสำหรับขั้นตอนนี้:

ด้ายฝ้ายด้ายฝ้าย1 as required

เครื่องมือที่ต้องใช้:

ปากกาจับชิ้นงานหน้าโต๊ะปากกาจับชิ้นงานหน้าโต๊ะ
สว่านมือสว่านมือ
กรรไกรกรรไกร
3

Soak in beeswax

Melt beeswax in a double boiler and draw each covered wire slowly through it. Wipe off the excess and let it set.

วัสดุสำหรับขั้นตอนนี้:

ขี้ผึ้งขี้ผึ้ง1 as required

เครื่องมือที่ต้องใช้:

หม้อตุ๋นสองชั้นหม้อตุ๋นสองชั้น
แผ่นให้ความร้อนแผ่นให้ความร้อน
4

Twist them together

Lay the covered wires side by side, clamp one end and twist them together evenly with the drill.

เครื่องมือที่ต้องใช้:

ปากกาจับชิ้นงานหน้าโต๊ะปากกาจับชิ้นงานหน้าโต๊ะ
สว่านมือสว่านมือ
5

Cover the bundle

Wind an outer layer of cotton over the twisted bundle and wax it again.

วัสดุสำหรับขั้นตอนนี้:

ด้ายฝ้ายด้ายฝ้าย1 as required
ขี้ผึ้งขี้ผึ้ง1 as required

เครื่องมือที่ต้องใช้:

ปากกาจับชิ้นงานหน้าโต๊ะปากกาจับชิ้นงานหน้าโต๊ะ
หม้อตุ๋นสองชั้นหม้อตุ๋นสองชั้น
แผ่นให้ความร้อนแผ่นให้ความร้อน
6

Test it

Strip the ends. With a multimeter check each wire end to end, and check that no two wires touch.

เครื่องมือที่ต้องใช้:

คีมปอกสายไฟคีมปอกสายไฟ
มัลติมิเตอร์มัลติมิเตอร์
7

Limits

Cotton insulation is only good for low temperatures, up to about 105 °C (Wikipedia, Magnet wire), and for dry places and low voltages such as instrument leads. The method is general workshop practice, ours.

วัสดุ

3
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง

เครื่องมือที่จำเป็น

7

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...