ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)
Charlie

สร้างโดย

Charlie

4. พฤศจิกายน 2026DE
12
0
0
0
0

Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)

How a rubber works of 1913 turned raw rubber into a 'mixing' ready for shaping and curing: the rubber is washed between corrugated rolls under running water, dried on racks, broken down on hot smooth rolls until plastic, and then worked together with fillers and finally sulphur into an even dough. Very few goods were made of rubber and sulphur alone: pure mixings cost too much and are too soft for most uses. Unknown: which fillers, and how much of them and of sulphur. Thorpe names the kinds of materials but gives no mixing. Source: T. E. Thorpe, Dictionary of Applied Chemistry vol. IV (1913), pp. 586-587. Picture: Fig. 1, a washing machine.
ระดับกลาง
3-4 days drying

คำแนะนำ

1

Steep and wash the rubber

Cut the raw rubber into lumps or slabs and steep them for some hours in warm water. Pass them again and again through corrugated, diamond-cut or fluted rolls running at a speed difference of 6 : 4 down to one tooth, with a stream of water on the rubber, until the rough crepe-like sheet is clean and thin.

วัสดุสำหรับขั้นตอนนี้:

ยางแผ่นรมควันยางแผ่นรมควัน1 raw rubber
น้ำน้ำ1 warm, then running

เครื่องมือที่ต้องใช้:

เครื่องบดผสมยางสองลูกกลิ้งเครื่องบดผสมยางสองลูกกลิ้ง
2

Dry on racks

Hang the sheet on racks in a drying room until it holds only about 0.25-0.5 per cent moisture: about 3-4 days at about 80°F with good ventilation. Cooler, drier air is better, as warm rubber turns soft and tacky.

เครื่องมือที่ต้องใช้:

ชั้นตากแห้งชั้นตากแห้ง
3

Break it down

Pass the dry rubber repeatedly through the steam-heated smooth rolls of the mixing machine, which run at different speeds, tightening the rolls gradually until the rubber is thoroughly plastic.

เครื่องมือที่ต้องใช้:

เครื่องบดผสมยางสองลูกกลิ้งเครื่องบดผสมยางสองลูกกลิ้ง
4

Mix in the fillers and sulphur

Add the other materials gradually: reclaimed rubber, ground waste, 'substitute' and other organic fillers first, then the minerals and the sulphur last. Work it into a thoroughly even dough without overworking ('tiring') the rubber.

วัสดุสำหรับขั้นตอนนี้:

วัสดุที่ไม่ทราบวัสดุที่ไม่ทราบ1 fillers and minerals; not given
ผงกำมะถันผงกำมะถัน1 amount not given

เครื่องมือที่ต้องใช้:

เครื่องบดผสมยางสองลูกกลิ้งเครื่องบดผสมยางสองลูกกลิ้ง

วัสดุ

4
  • ตัวยึดตำแหน่ง
  • 1 warm, then running
    ตัวยึดตำแหน่ง
  • 1 fillers and minerals; not given
    ตัวยึดตำแหน่ง
  • 1 amount not given
    ตัวยึดตำแหน่ง

เครื่องมือที่จำเป็น

2

พิมพ์เขียวนี้สร้าง

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...