Хамтын ажиллагаа
УРЛАГ
ГОО САЙХАН БА ЭРҮҮЛ МЭНД
ГАРААР ХИЙСЭН
СОЁЛ БА ТҮҮХ
ҮЗВЭР НААДАМ
БАЙГАЛЬ ОРЧИН
ХООЛ БА УНДАА
УРВУУ ИНЖЕНЕРЧЛЭЛ
ШИНЖЛЭХ УХААН
СПОРТ
ТЕХНОЛОГИ
ӨМСДӨГ ХЭРЭГСЭЛ
Electronic Analytical Balance: a Coil Current in Place of Weights (Akers et al., 1977)
Penny

Зохиогч

Penny

2. Арван нэгдүгээр сар 2026DK
6
0
0
0
0

Electronic Analytical Balance: a Coil Current in Place of Weights (Akers et al., 1977)

The equal-arm balance with its weights replaced by electricity. The pan sits on a coil in the gap of a permanent magnet. A load pushes it down; capacitor rings sense the smallest movement, and a servo drives just enough current through the coil to lift it back to its rest position. That current is the weight. Result: a balance that reads the weight in grams or ounces on a digital display, with no weights to handle, and tare by its circuit. Source: C. B. Akers and others (Arbor Laboratories), US Patent 4,034,819 (1977). Unknown: the resolution, capacity, magnet type, materials and sizes; the circuits are given as blocks only. Picture: patent drawing.
Дээд шат
2 weeks

Зааварчилгаа

1

Build the magnet circuit

Stack permanent magnets into a column with a soft iron core. Enclose them in an annular outer housing with end caps, shaped so the field crosses a narrow annular air gap at a constriction. Keep the whole structure symmetrical about its vertical axis. Mount it on a support plate fixed to an upright, such as a housing panel on a base. Not given: the magnet type, materials and sizes.

Энэ алхмын материал:

Жижиг соронзЖижиг соронз1 column
Төмөр туйванТөмөр туйван1 soft iron core
Тодорхойгүй металлТодорхойгүй металл1 housing and end caps
Тодорхойгүй материалТодорхойгүй материал1 support plate, panel, base

Шаардлагатай багаж:

Халив иж бүрдэлХалив иж бүрдэл
Тодорхойгүй хэмжээсТодорхойгүй хэмжээс
2

Hang the coil in the gap

Wind the coil tightly round the middle of a light bobbin that surrounds the core, the coil sitting in the air gap. Tabs at both ends of the bobbin pass out through holes in the end caps to suspension frames. Hang the frames from thin springy cantilevers fixed to the upright, so the bobbin can only move a short way straight up and down. Keep the bobbin and its suspension as light as possible. Put the weighing pan on top. Ours: enamelled wire.

Энэ алхмын материал:

Пааландсан зэс утасПааландсан зэс утас1 coil
Тодорхойгүй материалТодорхойгүй материал1 bobbin, frames, cantilevers
Жингийн тавагЖингийн таваг1 ширхэг

Шаардлагатай багаж:

Тодорхойгүй хэмжээсТодорхойгүй хэмжээс
3

Fit the capacitor rings

Mount four capacitor rings inside the outer housing, two above and two below the air gap, facing matching rings on the bobbin. Cross-connect them so a tilt of the bobbin cancels out and only up-and-down movement shows. Connect them to a signal generator: as the bobbin moves, one set's capacitance rises and the other's falls, and the difference becomes the control voltage.

Энэ алхмын материал:

Тодорхойгүй металлТодорхойгүй металл1 rings
Интеграл схемИнтеграл схем1 sensing circuit
Холбох утасХолбох утас1 ширхэг
Гагнуурын утасГагнуурын утас1 a little

Шаардлагатай багаж:

Гагнуурын хэрэгсэлГагнуурын хэрэгсэл
4

Close the servo loop and read the current

Feed the control voltage to a d.c. servo that drives current through the coil, through a flexible lead, until the bobbin is back at its rest position. Pass that current through a large stable resistor, a thermal resistor that corrects for temperature and a calibration potentiometer: the voltage across them stands for the weight. A separate circuit (comparators, saw-tooth generator, oscillator and counter) turns it into a count read out as grams or ounces. Tare is ordinary circuit logic. Ours: a segment LCD; check with calibration weights.

Энэ алхмын материал:

Интеграл схемИнтеграл схем1 servo and counting circuits
ЭсэргүүцэлЭсэргүүцэл2 stable resistor, thermal resistor
ПотенциометрПотенциометр1 calibration
Сегмент шингэн болор дэлгэцСегмент шингэн болор дэлгэц1 display
Гагнуурын утасГагнуурын утас1 a little

Шаардлагатай багаж:

Гагнуурын хэрэгсэлГагнуурын хэрэгсэл
Шалгалтын жингийн багцШалгалтын жингийн багц

Материал

12

Шаардлагатай багаж

4

Холбоотой загварууд

Эдгээр загварууд мэдлэг хуваалцдаг — арга техник, материал эсвэл зарчим

CC0 Нийтийн домэйн

Энэ загвар CC0 дор гаргагдсан. Та зөвшөөрөл авахгүйгээр хуулах, өөрчлөх, түгээх, ашиглах боломжтой.

Загвараар дамжуулан бүтээгдэхүүн худалдаж авч Бүтээгчийг дэмжээрэй Бүтээгчийн шимтгэл Борлуулагчаар тогтоосон, эсвэл энэ загварын шинэ хувилбар үүсгэж орлогоо хуваахын тулд өөрийн загварт холбоос болгон оруулна уу.

Хэлэлцүүлэг

(0)

Нэвтрэх хэлэлцүүлэгт нэгдэхийн тулд

Сэтгэгдлүүдийг ачаалж байна...