SENI
KECANTIKAN & KESEJAHTERAAN
KRAFTANGAN
BUDAYA & SEJARAH
HIBURAN
ALAM SEKITAR
MAKANAN & MINUMAN
KEJURUTERAAN TERBALIK
SAINS
SUKAN
TEKNOLOGI
BOLEH PAKAI
Forged Centre Punch, Hardened and Tempered
A centre punch marks the spot for a drill. It is forged from tool steel like a cold chisel: the point is tapered at a yellow heat and ground to an angle between 60° and 90°. Only the point is hardened: heat the end about 3 inches back, dip the point in water at about 70 °F (21 °C) while moving it, polish it, and let the heat left in the shank run down until the point turns brown or purple, about 500–525 °F (260–275 °C); then cool it completely. A good punch marks tool steel without its point going dull.
Pertengahan
1–2 hours
Arahan
1
1
Forge the taper
Forge the taper
Heat the end of the tool steel bar to a yellow heat and forge a long taper to a blunt point; finish just above the hardening heat, never hammering it black.
Bahan untuk langkah ini:
Bar keluli alat segi lapan1 kepingAlatan diperlukan:
Relau tukang besi
Andas
Tukul Tempa
Penyepit Tukang Besi2
2
Cool and grind
Cool and grind
Let it cool slowly, then grind the point to an angle between 60° and 90°.
Alatan diperlukan:
Batu canai roda3
3
Harden the point
Harden the point
Reheat about 3 inches of the point end to the hardening heat, keeping the tip high in the fire. Dip the point into clean water at about 70 °F, moving it so no sharp line forms, then plunge briefly and lift out with heat left in the shank.
Alatan diperlukan:
Relau tukang besi
BaldiPenyepit Tukang Besi4
4
Temper
Temper
Polish the point quickly and watch the colours run down to it; when the point is brown or purple, cool the whole punch completely.
Alatan diperlukan:
Kain emeriBaldi5
5
Test
Test
Strike a mark in a piece of tool steel; the point should not dull.
Alatan diperlukan:
Tukul TempaBahan
1- 1 kepingPemegang Tempat
Blueprint ini membuat
Blueprint berkaitan
Blueprint ini berkongsi pengetahuan — teknik, bahan atau prinsip
CC0 Domain Awam
Blueprint ini dikeluarkan di bawah CC0. Anda bebas menyalin, mengubah, mengedar, dan menggunakan karya ini untuk sebarang tujuan, tanpa meminta kebenaran.
Sokong Pembuat dengan membeli produk melalui Blueprint mereka di mana mereka memperoleh Komisen Pembuat ditetapkan oleh Penjual, atau cipta iterasi baru Blueprint ini dan sertakan ia sebagai sambungan dalam Blueprint anda sendiri untuk berkongsi hasil.