कला
सुन्दरता र कल्याण
हस्तकला
संस्कृति र इतिहास
मनोरञ्जन
वातावरण
खाना र पेय
रिभर्स इन्जिनियरिङ
विज्ञान
खेलकुद
प्रविधि
पहिर्न मिल्ने
Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted
Penny

सिर्जनाकर्ता

Penny

14. अक्टोबर 2026DK
१८
०
०
०
०

Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted

A cable of several insulated wires in one bundle, such as the four leads of a strain-gauge bridge. Each copper wire is wrapped in cotton thread and soaked in beeswax, then the wires are twisted together and covered again.
शुरुआती
An afternoon

निर्देशनहरू

1

Cut the conductors

Cut one copper wire per conductor (four for a bridge), a little longer than the cable.

यस चरणका सामग्री:

तामाको तारतामाको तार4 length

चाहिने औजार:

तारको बोक्रा उप्काउने औजारतारको बोक्रा उप्काउने औजार
2

Wrap each wire in cotton

Clamp one end in the vise and the other in the hand drill's chuck, keeping it taut. Wind cotton thread on in a close spiral with no gaps, then a second layer the opposite way.

यस चरणका सामग्री:

सुतीको धागोसुतीको धागो1 as required

चाहिने औजार:

बेन्चको भाइसबेन्चको भाइस
हाते ड्रिलहाते ड्रिल
कैँचीकैँची
3

Soak in beeswax

Melt beeswax in a double boiler and draw each covered wire slowly through it. Wipe off the excess and let it set.

यस चरणका सामग्री:

मौरीको मैनमौरीको मैन1 as required

चाहिने औजार:

दोहोरो भाँडोदोहोरो भाँडो
तताउने प्लेटतताउने प्लेट
4

Twist them together

Lay the covered wires side by side, clamp one end and twist them together evenly with the drill.

चाहिने औजार:

बेन्चको भाइसबेन्चको भाइस
हाते ड्रिलहाते ड्रिल
5

Cover the bundle

Wind an outer layer of cotton over the twisted bundle and wax it again.

यस चरणका सामग्री:

सुतीको धागोसुतीको धागो1 as required
मौरीको मैनमौरीको मैन1 as required

चाहिने औजार:

बेन्चको भाइसबेन्चको भाइस
दोहोरो भाँडोदोहोरो भाँडो
तताउने प्लेटतताउने प्लेट
6

Test it

Strip the ends. With a multimeter check each wire end to end, and check that no two wires touch.

चाहिने औजार:

तारको बोक्रा उप्काउने औजारतारको बोक्रा उप्काउने औजार
मल्टिमिटरमल्टिमिटर
7

Limits

Cotton insulation is only good for low temperatures, up to about 105 °C (Wikipedia, Magnet wire), and for dry places and low voltages such as instrument leads. The method is general workshop practice, ours.

सामग्री

3

आवश्यक उपकरणहरू

7

CC0 सार्वजनिक डोमेन

यो ब्लुप्रिन्ट CC0 अन्तर्गत जारी गरिएको छ। तपाईं अनुमति नसोधी प्रतिलिपि, परिमार्जन, वितरण र प्रयोग गर्न सक्नुहुन्छ।

ब्लुप्रिन्ट मार्फत उत्पादनहरू किनेर सिर्जनाकर्तालाई सहयोग गर्नुहोस् सिर्जनाकर्ता कमिसन विक्रेताले तोकेको, वा यो ब्लुप्रिन्टको नयाँ संस्करण बनाउनुहोस् र आम्दानी बाँड्न आफ्नो ब्लुप्रिन्टमा जडानको रूपमा समावेश गर्नुहोस्।

छलफल

(0)

लग इन छलफलमा सामेल हुन

टिप्पणीहरू लोड गर्दै...