सहयोग
कला
सुन्दरता र कल्याण
हस्तकला
संस्कृति र इतिहास
मनोरञ्जन
वातावरण
खाना र पेय
रिभर्स इन्जिनियरिङ
विज्ञान
खेलकुद
प्रविधि
पहिर्न मिल्ने
Woven-Reed Footstool: Nailed Dowel Frame, Wound Posts, Woven Top and Pairing-Weave Apron (Boy Mechanic, 1919)
Tex

सिर्जनाकर्ता

Tex

14. नोभेम्बर 2026FO
७
०
०
०
०

Woven-Reed Footstool: Nailed Dowel Frame, Wound Posts, Woven Top and Pairing-Weave Apron (Boy Mechanic, 1919)

Charles M. Miller's reed footstool from The Boy Mechanic, Book 3 (1919): a frame of 3/4 in dowel rails and posts with crossed 5/8 in braces, nailed through drilled holes, the posts and rails wound with flat reed, the top woven over No. 4 spokes and the apron in pairing weave, finished with a broken-down roll.
मध्यम
About 2 days

निर्देशनहरू

1

Cut list

Jupyter नोटबुक लोड हुँदैछ…
2

Read The Boy Mechanic, Book 3

"Each piece of reed furniture has a framework, usually of dowels." The reed sizes are those of his reed basket (Boy Mechanic, Book 2).
3

Cut and drill the frame

Cut two side rails 3/4 by 14 in, two end rails 3/4 by 9 in, four posts 3/4 by 7 in and two braces 5/8 by 17 in (trimmed to fit later). Notch the rail and brace ends with a coping saw to seat on the posts. Before assembly drill the spoke holes, 1/8 in for No. 4 reed, combining the top and end-side spoke holes as in Fig. 4 and drilling the side-rail holes straight (Fig. 2).

यस चरणका सामग्री:

काठको चुकुलकाठको चुकुल4 टुक्रा

चाहिने औजार:

वक्र काट्ने आरावक्र काट्ने आरा
हाते ड्रिलहाते ड्रिल
सिसाकलमसिसाकलम
नाप्ने फित्तानाप्ने फित्ता
4

Nail the frame

Run the posts to the top of the frame and nail through them into the rail ends with ordinary 4-penny nails, drilling 1/16 in holes first. Set the side rails about 1/16 in below the post tops. Halve the braces at the centre on a slant so their tops lie level, try them, and nail them without pulling the frame out of square (Fig. 1).

यस चरणका सामग्री:

काँटीकाँटी1 टुक्रा

चाहिने औजार:

हाते ड्रिलहाते ड्रिल
घनघन
वक्र काट्ने आरावक्र काट्ने आरा
5

Wind the posts and end rails

Cover the post tops with short pieces of winding reed tacked on with shoemaker's tacks, crossing in turn (Figs. 5, 6). Wind the end rails, marking each hole with pencil as the winding passes it; then open each hole through the winding with a bodkin (Fig. 7).

यस चरणका सामग्री:

चिरिएको निगालोचिरिएको निगालो1 टुक्रा
लास्टिङ किलालास्टिङ किला1 टुक्रा

चाहिने औजार:

घनघन
आर (छेड्ने सियो)आर (छेड्ने सियो)
सिसाकलमसिसाकलम
6

Weave the top

Put the 32 in No. 4 spokes through one end rail, down and out at the ends. Weave with a single No. 3 weaver, and after 3/4 in add a short extra spoke beside each spoke, weaving the pair as one; wind the weaver twice round the side rail each time. Insert the spokes in the other end rail before the weaving is within 2 or 3 in of it (Fig. 8).

यस चरणका सामग्री:

बेतबेत1 टुक्रा

चाहिने औजार:

कैँचीकैँची
२० लिटरको बाल्टिन२० लिटरको बाल्टिन
स्पन्जस्पन्ज
7

Wind braces and posts, weave the apron

Wind the braces and posts, three strips round the post and tacked where each brace meets it, and both braces together where they cross (Fig. 9); finish the posts with brass caps or wind to within 1/8 in of the bottom. With the stool upside down, insert short spokes in the under side of the side rails and weave the apron in pairing weave, always passing one weaver twice round each post (Figs. 10-12). Cut the extra spokes even and break down the spokes into a roll, tucking the ends inside (Figs. 13-15). Singe off stray fibres carefully with a gas flame or blowtorch.

यस चरणका सामग्री:

चिरिएको निगालोचिरिएको निगालो1 टुक्रा
बेतबेत1 टुक्रा
लास्टिङ किलालास्टिङ किला1 टुक्रा

चाहिने औजार:

कैँचीकैँची
प्रोपेन टर्चप्रोपेन टर्च
स्पन्जस्पन्ज
२० लिटरको बाल्टिन२० लिटरको बाल्टिन
8

Troubleshooting

Reed weaving troubleshooting.

Flow

Loading...
9

History and honest limits

From "A Woven-Reed Footstool" by Charles M. Miller, in **The Boy Mechanic, Book 3**, Popular Mechanics, 1919 (Project Gutenberg 71856; checked on the archive.org scan boymechanic0003unse, pp. 255-258). Fig. 2 shows the hole positions without figures, and he mentions an optional chloride-of-lime bleach that we leave out. The tools and metric figures are ours.

सामग्री

5
  • प्लेसहोल्डर
  • 1 टुक्रा
    प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • 1 टुक्रा
    प्लेसहोल्डर

आवश्यक उपकरणहरू

10
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • 1 vendor sell this, none ship to you yet
    प्लेसहोल्डर
  • 1 vendor sell this, none ship to you yet
    प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर
  • प्लेसहोल्डर

सम्बन्धित ब्लुप्रिन्ट

यी ब्लुप्रिन्टहरूले ज्ञान साझा गर्छन् — प्रविधि, सामग्री वा सिद्धान्त

CC0 सार्वजनिक डोमेन

यो ब्लुप्रिन्ट CC0 अन्तर्गत जारी गरिएको छ। तपाईं अनुमति नसोधी प्रतिलिपि, परिमार्जन, वितरण र प्रयोग गर्न सक्नुहुन्छ।

ब्लुप्रिन्ट मार्फत उत्पादनहरू किनेर सिर्जनाकर्तालाई सहयोग गर्नुहोस् सिर्जनाकर्ता कमिसन विक्रेताले तोकेको, वा यो ब्लुप्रिन्टको नयाँ संस्करण बनाउनुहोस् र आम्दानी बाँड्न आफ्नो ब्लुप्रिन्टमा जडानको रूपमा समावेश गर्नुहोस्।

छलफल

(0)

लग इन छलफलमा सामेल हुन

टिप्पणीहरू लोड गर्दै...