कला
सुन्दरता र कल्याण
हस्तकला
संस्कृति र इतिहास
मनोरञ्जन
वातावरण
खाना र पेय
रिभर्स इन्जिनियरिङ
विज्ञान
खेलकुद
प्रविधि
पहिर्न मिल्ने
The Finger-Valve Fountain Bath Brush: Press to Run, Let Go to Stop
YourGrandma

सिर्जनाकर्ता

YourGrandma

6. अक्टोबर 2026IS
३१
०
०
०
०

The Finger-Valve Fountain Bath Brush: Press to Run, Let Go to Stop

A bath brush fed from a hose runs all the time, or needs a tap out of reach. Daniel S. Koons and William F. Moughler of Chicago received US 634,527, dated 10 October 1899, for "a fountain bath-brush": a false back with a water passage, joined to the brush by a hollow screw whose perforated head lets the water out among the bristles, with a valve that a spring and the water pressure hold shut until a finger presses its stem, and a strap that holds the hand to the brush. This rung works out the finger force, then builds the false back on a scrub brush with a tyre valve as the finger valve, and measures the force and the flow.
मध्यम
About 3 hours

निर्देशनहरू

1

Force to open the valve

Jupyter नोटबुक लोड हुँदैछ…
2

A brush that feeds itself before it

The embedded blueprint feeds soap from inside a shaving brush. Koons and Moughler feed water, and give the finger a valve to start and stop it.
3

Read US 634,527

"Said valve is held normally closed by means of a spring 9 and also by the water-pressure, as will be obvious." "A strap k is secured at the sides of said back B' and passes over the latter, so that by inserting the hand between said back B' and said strap k the brush can be firmly held and the fingers at the same time kept in position to operate the valve."
4

Bore the false back

Cut a hardwood block 120 × 50 × 22 mm. Drill a 6 mm passage 90 mm along its centre from one end, and a 6 mm hole down from the top to meet it 30 mm from the far end.

यस चरणका सामग्री:

कडा काठको ढिक्काकडा काठको ढिक्का1 टुक्रा

चाहिने औजार:

बेन्चको भाइसबेन्चको भाइस
तारविनाको ड्रिलतारविनाको ड्रिल
केन्द्र टुप्पो भएका ड्रिल बिटको सेटकेन्द्र टुप्पो भएका ड्रिल बिटको सेट
रुलररुलर
सफा सुरक्षा चस्मासफा सुरक्षा चस्मा
5

Fit the finger valve

Drill a hole across the passage 20 mm from the inlet to take a tyre valve, pin upward. Epoxy it in so the water must pass through it.

यस चरणका सामग्री:

टायरको भल्भटायरको भल्भ1 टुक्रा
दुई भागको इपोक्सीदुई भागको इपोक्सी1 टुक्रा

चाहिने औजार:

तारविनाको ड्रिलतारविनाको ड्रिल
ड्रिल टुप्पाको सेटड्रिल टुप्पाको सेट
6

Join it to the brush

Drill a 6 mm hole through the scrub brush's back to line up with the outlet. Cut a rubber gasket, and screw the block on with four wood screws.

यस चरणका सामग्री:

माझ्ने ब्रसमाझ्ने ब्रस1 टुक्रा
रबरको पातारबरको पाता1 टुक्रा
काठको पेच #8 × १"काठको पेच #8 × १"1 टुक्रा

चाहिने औजार:

तारविनाको ड्रिलतारविनाको ड्रिल
ड्रिल टुप्पाको सेटड्रिल टुप्पाको सेट
हस्तकलाको चक्कुहस्तकलाको चक्कु
स्क्रुड्राइभर सेटस्क्रुड्राइभर सेट
7

Strap and hose

Screw a strip of rubber sheet across the block as a hand strap, over the valve's side. Fit a hose connector to the inlet with brass fittings and PTFE tape.

यस चरणका सामग्री:

रबरको पातारबरको पाता1 टुक्रा
काठको पेच #8 × १"काठको पेच #8 × १"1 टुक्रा
पित्तलका फिटिङपित्तलका फिटिङ1 टुक्रा
PTFE चूडी सिल टेपPTFE चूडी सिल टेप1 टुक्रा

चाहिने औजार:

स्क्रुड्राइभर सेटस्क्रुड्राइभर सेट
मिलाउन मिल्ने पानामिलाउन मिल्ने पाना
8

The patent drawing

US 634,527 drawing sheet, public domain (expired patent).
चरण 8 - Image 1
9

Measure force and flow

Connect the garden hose and turn on the tap. Press the valve pin with the force meter's hook until water runs; note the force. Hold it open over the jug for 30 s and read the flow.
चरण 9 - Image 1

यस चरणका सामग्री:

पानीपानी1 टुक्रा

चाहिने औजार:

बलमापक (स्प्रिङ तराजु)बलमापक (स्प्रिङ तराजु)
नाप्ने जगनाप्ने जग
रोकघडीरोकघडी
बगैँचा पाइपबगैँचा पाइप
10

A valve that drips, sticks or barely flows

Finger-valve bath brush troubleshooting.

Flow

Loading...
11

History and honest limits

**Daniel S. Koons** and **William F. Moughler** of Chicago filed US 634,527 on 21 September 1898; it is dated 10 October 1899. They called it a self-cleansing brush. Its handle is telescopic, with a stuffing-box between the two members, and the hose can be led through it to the brush; a second form uses a nozzle as the screw joining the backs. They did not limit it to the bath. **Honest limits.** A tyre valve stands in for their seated valve and stem, and wood screws for their hollow screw. Your forces and flows are the result.

सामग्री

9

आवश्यक उपकरणहरू

13

CC0 सार्वजनिक डोमेन

यो ब्लुप्रिन्ट CC0 अन्तर्गत जारी गरिएको छ। तपाईं अनुमति नसोधी प्रतिलिपि, परिमार्जन, वितरण र प्रयोग गर्न सक्नुहुन्छ।

ब्लुप्रिन्ट मार्फत उत्पादनहरू किनेर सिर्जनाकर्तालाई सहयोग गर्नुहोस् सिर्जनाकर्ता कमिसन विक्रेताले तोकेको, वा यो ब्लुप्रिन्टको नयाँ संस्करण बनाउनुहोस् र आम्दानी बाँड्न आफ्नो ब्लुप्रिन्टमा जडानको रूपमा समावेश गर्नुहोस्।

छलफल

(0)

लग इन छलफलमा सामेल हुन

टिप्पणीहरू लोड गर्दै...