Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)
Penny

Autor

Penny

14. listopad 2026DK
4
0
0
0
0

Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)

A current meter from a wooden ring wound with eight turns of wire and a pocket compass at its centre: set the coil north-south, pass the current, and the needle's swing gives the amperes from a table (0.5 A at 45 degrees).
Średniozaawansowany
An afternoon

Instrukcje

1

The tangent law

Wczytywanie notatnika Jupyter…
2

Read the Boy Mechanic

"Any deviation from the dimensions will cause errors in the results obtained by its use."
3

Make the ring

From 1/2 in wood cut a ring 10-1/2 in outside and 9 in inside. Glue on each side a 1/4 in ring, 9 in inside and 11 in outside, to form a 1/4 in channel round the edge (or turn it from solid). Use brass screws and brads only.

Materiały do tego kroku:

Deska z drewna liściastegoDeska z drewna liściastego1 sztuka
Klej do drewnaKlej do drewna1 sztuka

Potrzebne narzędzia:

Piłka włosowaPiłka włosowa
KompasKompas
4

Wind the coil

Wind 8 turns of No. 16 insulated magnet wire in the channel and tie the ends.

Materiały do tego kroku:

Drut miedziany emaliowanyDrut miedziany emaliowany1 sztuka
SznurekSznurek1 sztuka
5

Base

Cut a round base 11 in across with a slot 1 in wide and 6-5/16 in long in the middle. Stand the ring in it with its inner surface level with the top of the base, held by a small strip screwed to the base. Fit two binding posts and connect the coil ends.

Materiały do tego kroku:

Deska z drewna liściastegoDeska z drewna liściastego1 sztuka
Zacisk bananowyZacisk bananowy1 sztuka
Wkręty do drewnaWkręty do drewna1 sztuka

Potrzebne narzędzia:

Piłka włosowaPiłka włosowa
Świder korbowy z wiertłemŚwider korbowy z wiertłem
6

Mount the compass

Fix two strips 1/4 x 5/8 x 11 in across the ring with their top edges exactly through its centre, and set a pocket compass about 1-1/4 in across in them, needle centre at the ring centre, zero half-way between the strips. Coat everything with brown shellac.

Materiały do tego kroku:

Deska z drewna liściastegoDeska z drewna liściastego1 sztuka
Kompas magnetycznyKompas magnetyczny1 sztuka
Politura szelakowaPolitura szelakowa1 sztuka

Potrzebne narzędzia:

Piła ręcznaPiła ręczna
7

Set up and read

Keep iron, steel and magnets away. On a level table turn it until the needle lies in the plane of the coil at zero. Connect the circuit; 45 degrees means 1/2 ampere; use the table for other angles. His table holds near Chicago and east of it north of the Ohio; multiply by 1.3 south of the Ohio and east of the Mississippi.
8

Troubleshooting

Galvanometer troubleshooting.

Flow

Loading...
9

History and honest limits

From **The Boy Mechanic, Book 1** (Popular Mechanics, 1913), pp. 150-151 (checked on the archive.org scan boymechanic0000unse_n5a8). His table equals 0.5 x tan(angle); the field-strength note and modern enamelled wire are ours.

Materiały

8

Wymagane narzędzia

4

Według tego planu powstaje

Powiązane blueprinty

Te blueprinty dzielą się wiedzą — technikami, materiałami lub zasadami

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...