ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่

Steam Still: a Horizontal Still with Steam Coils and Scrubbing Tower (Bell, 1923)
A refinery still heated only by steam: a horizontal riveted shell with closed steam coils and open steam sprays in the bottom, and a tower of broken stone or tile on top where rising vapour meets the incoming feed. Used to re-run naphtha and kerosene and to strip naphtha from lubricating stocks without a fire.
Variable: batch, semi-continuous, or continuous with four baffled compartments. Bell's Fig. 39 still is 10 x 30 ft.
Source: H. S. Bell, American Petroleum Refining (1923), pp. 105-109. Unknown: plate thickness. Picture: Fig. 39 of the book.
ผู้เชี่ยวชาญ
Unknown
คำแนะนำ
1
1
Build the shell
Build the shell
Rivet a horizontal cylindrical shell (Fig. 39: 10 x 30 ft) with the plate seams running straight round it (Fig. 36), cheaper than a fire still's layout; hemispherical heads are an expense with no clear reason. Fit a manhole, a drain, flanges for oil and steam and a nozzle for the tower.
วัสดุสำหรับขั้นตอนนี้:
แผ่นเหล็กกล้าละมุน1 shell, heads
เหล็กฉากเหล็กกล้าละมุน1 ชิ้น
หมุดย้ำเหล็กกล้า1 ชิ้นเครื่องมือที่ต้องใช้:
เครื่องปั๊มเจาะ
ค้อนย้ำหมุด
ขนาดที่ไม่ทราบ2
2
Fit coils, sprays and baffles
Fit coils, sprays and baffles
Lay closed steam coils in the bottom with open steam sprays beside them. For continuous running, divide the shell into four compartments with cross baffles, leaving small openings at the bottom so condensed water drains to the water pot at the rear. Give the coils 62.5 sq ft of heating surface per 100 gallons taken overhead per hour: 33 % in the first compartment, 28 % in the second, 22 % in the third, 17 % in the rear. A semi-continuous still needs no baffles.
วัสดุสำหรับขั้นตอนนี้:
ขดท่อไอน้ำ1 62.5 sq ft per 100 gal/h
ท่อเหล็ก (ผนังหนา ปลายเกลียว)1 open sprays, header
วาล์วไอน้ำ2 ชิ้น
แผ่นเหล็กกล้าละมุน1 bafflesเครื่องมือที่ต้องใช้:
ค้อนย้ำหมุด3
3
Add the scrubbing tower
Add the scrubbing tower
Mount a combined scrubbing and dephlegmating tower on the still, filled with broken stone or tile. The feed enters at its top and trickles down against the rising vapour and steam, which condenses the heavier fractions and carries them back to the still; the vapour goes on to the condensers.
วัสดุสำหรับขั้นตอนนี้:
แผ่นเหล็กกล้าละมุน1 tower
หมุดย้ำเหล็กกล้า1 ชิ้น
หินย่อย1 broken stone or tileเครื่องมือที่ต้องใช้:
ค้อนย้ำหมุด4
4
Set it
Set it
Settings are simple: brick cross piers or steel frames, with brick or concrete dividing walls between stills where they must carry the tower and heat exchangers. Pipe the residual outlet with a valve.
วัสดุสำหรับขั้นตอนนี้:
อิฐ1 cross piers
วาล์วประตูน้ำ1 residualเครื่องมือที่ต้องใช้:
เกรียงก่อวัสดุ
9- 1 towerตัวยึดตำแหน่ง
- 1 ชิ้นตัวยึดตำแหน่ง
- 1 ชิ้นตัวยึดตำแหน่ง
- 1 62.5 sq ft per 100 gal/hตัวยึดตำแหน่ง
- 1 open sprays, headerตัวยึดตำแหน่ง
- 2 ชิ้นตัวยึดตำแหน่ง
- 1 broken stone or tileตัวยึดตำแหน่ง
- 1 cross piersตัวยึดตำแหน่ง
- 1 residualตัวยึดตำแหน่ง
วัสดุจากพิมพ์เขียวที่เชื่อมต่อ
พิมพ์เขียวนี้สร้าง
CC0 สาธารณสมบัติ
พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต
สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

