Collaboration
ART
BEAUTY & WELLNESS
CRAFT
CULTURE & HISTORY
ENTERTAINMENT
ENVIRONMENT
FOOD & DRINKS
REVERSE ENGINEERING
SCIENCES
SPORTS
TECHNOLOGY
WEARABLES

Half-Round Taper Reamer: Tool Steel Turned to the Taper, Filed Flat to the Centre Line, Hardened (Griswold, Amateur Work, 1905)
The simplest home-made taper reamer, from Robert Gibson Griswold's Tool Making for Amateurs (Boston, 1905): tool steel turned to the taper wanted (his was 1/8 in. per foot), one side filed away exactly to the centre line so that two cutting edges remain, then hardened and ground on the flat face only. It reams a very smooth conical hole.
Intermediate
Two to three hours
Instructions
1
1
His taper
His taper
Loading Jupyter Notebook...
2
2
Read Griswold
Read Griswold
"Turn a piece of tool steel to the proper taper and then file away one side until the flat surface coincides with the center line."
3
3
Turn the taper
Turn the taper
Turn a piece of tool steel in the lathe to the taper of the part the hole must fit (his: 1/8 in. per foot). Length and diameter are ours: a little longer than the hole and spanning its two diameters.
Materials for this step:
Tool Steel Bar1 pieceTools needed:
Metal Lathe
Caliper4
4
File to the centre line
File to the centre line
Hold it in the vice and file away one side until the flat face lies exactly on the centre line. This leaves a cutting edge on each side.
Tools needed:
Bench Vise
Files (Hand File)
Caliper5
5
Harden and grind
Harden and grind
Harden it (ours: heat to a cherry red and quench in water, temper to a straw colour), then grind on the flat side only, never on the round.
Tools needed:
Blacksmith Forge
Quench Bucket
Bench Grinder6
6
Troubleshooting
Troubleshooting
Reamer troubleshooting.
Flow
Loading...
7
7
History and honest limits
History and honest limits
From Robert Gibson Griswold, "Tool Making for Amateurs" VII, **Amateur Work** (Boston), vol. IV (1904-05), p. 128 (checked on the archive.org scan amateurwork04bostrich). He gives no size or temper for the reamer; those and the tools are ours. He finishes the hardened bushings with a copper lap and emery.
Materials
1- 1 piecePlaceholder
Tools Required
7- Placeholder
- 1 vendor sell this, none ship to you yetPlaceholder
- Placeholder
- Placeholder
- Placeholder
- Placeholder
- Placeholder
This blueprint makes
Related Blueprints
These blueprints share knowledge with this one — techniques, materials, or principles that connect them in the learning graph.
CC0 Public Domain
This blueprint is released under CC0. You are free to copy, modify, distribute, and use this work for any purpose, without asking permission.
Support the Maker by purchasing products through their Blueprint where they earn a Maker Commission set by Vendors, or create a new iteration of this Blueprint and include it as a connection in your own Blueprint to share revenue.

