UBUCIKO
UBUHLE NEMPILO
UBUCIKO BEZANDLA
AMASIKO NOMLANDO
EZOKUZIJABULISA
IMVELO
UKUDLA NEZIPHUZO
REVERSE ENGINEERING
IZAYENSI
EZEMIDLALO
UBUCHWEPHESHE
IZINTO EZIGQOKWAYO
Binding a Besom Broom — The Birch-Twig Broom on a Hazel Handle
The besom is the oldest broom: a fat bundle of springy birch twigs bound around a hazel or ash handle. Every household swept with one, and it cost nothing but a walk to the woods. There are no nails and no glue — the head is held by tight withy bindings and a single wooden peg, and it only grips harder as the birch dries and shrinks. This blueprint binds a besom from cut brush to finished broom using hand tools alone.
Oqalayo
3
Imiyalelo
1
1
Cut the birch brush
Cut the birch brush
Cut generous bundles of thin, whippy birch twigs — the 'brush'. Winter-cut birch, taken when the tree is bare, is springiest and lasts longest. Keep the twigs long and unbroken.
Izinto zokwakha zalesi sinyathelo:
Birch Brush1 inqwabaAmathuluzi adingekayo:
Billhook2
2
Wilt the twigs supple
Wilt the twigs supple
Lay the cut brush somewhere cool for a few days until the twigs lose their brittleness and bend without snapping. Supple twigs pack tightly and bind without cracking.
Izinto zokwakha zalesi sinyathelo:
Birch Brush1 inqwaba3
3
Cut and point the handle
Cut and point the handle
Cut a straight length of hazel or ash about a thumb-and-a-half thick for the handle. Trim it clean and whittle one end to a long blunt point so the brush seats around it.
Izinto zokwakha zalesi sinyathelo:
Green Wood Poles (1-2m)1 ucezuAmathuluzi adingekayo:
Billhook
Knife4
4
Soak the binding withies
Soak the binding withies
Soak split willow withies in water until they are fully flexible. These flexible ties will cinch the brush to the handle; they must bend sharply without breaking.
Izinto zokwakha zalesi sinyathelo:
Willow Withy2 izicucu
Water5 amalitha5
5
Lay the brush around the handle
Lay the brush around the handle
Stand the pointed handle upright and lay birch twigs evenly all the way around it, butt ends up along the handle and tips hanging down. Keep the bundle even so the finished broom is not lopsided.
Izinto zokwakha zalesi sinyathelo:
Birch Brush1 inqwaba6
6
Bind the top band
Bind the top band
Squeeze the twigs tight against the handle and wind a soaked withy hard around the bundle near the top of the brush. Pull it as tight as you can and twist and tuck the ends to lock the band.
Izinto zokwakha zalesi sinyathelo:
Willow Withy1 ucezu7
7
Bind the second band
Bind the second band
Wind a second withy band about a hand's width below the first and cinch it just as tight. Two bands stop the brush from splaying and spread the sweeping wear.
Izinto zokwakha zalesi sinyathelo:
Willow Withy1 ucezu8
8
Peg the head to the handle
Peg the head to the handle
Whittle a small hardwood peg. Start a hole through the handle between the bindings with the awl, then drive the peg through with the mallet so the head can never slide off the handle.
Amathuluzi adingekayo:
Knife
Awl
Wooden Mallet9
9
Trim the sweeping end
Trim the sweeping end
Trim the hanging tips of the brush level across the bottom with the billhook so the broom meets the floor evenly and sweeps cleanly.
Amathuluzi adingekayo:
Billhook10
10
Season the besom
Season the besom
Stand the finished besom in a dry place to season. As the birch dries it stiffens into a firm brush and the withy bindings shrink even tighter — the broom is ready to sweep.
Izinto
7- 1 inqwabaIsibambeli
- 1 ucezuIsibambeli
- 4 izicucuIsibambeli
- 5 amalithaIsibambeli
- 1 ucezuIsibambeli
- 1 ucezuIsibambeli
- 1 ucezuIsibambeli
Izinto Zokwakha Ze-Blueprint Exhunyiwe
Ama-blueprint ahlobene
Lama-blueprint abelana ngolwazi — amasu, izinto noma izimiso
CC0 Isizinda Somphakathi
Le blueprint ikhishwe ngaphansi kwe-CC0. Ukhululekile ukukopisha, ukuguqula, ukusabalalisa, nokusebenzisa ngaphandle kwemvume.
Sekela uMenzi ngokuthenga imikhiqizo nge-Blueprint yabo IKhomishane Yomenzi kumiswe ngabathengisi, noma dala inguqulo entsha yale Blueprint bese uyifaka njengoxhumaniso ku-Blueprint yakho ukuze wabelane ngemali engenayo.