སྒྱུ་རྩལ
མཛེས་སྡུག་དང་བདེ་ཐང
བཟོ་རིག
རིག་གནས་དང་ལོ་རྒྱུས
དགའ་སྟོན
ཁོར་ཡུག
ཟས་དང་བཏུང་རྫས
ཕྱིར་འཕྲུལ་རིག
ཚན་རིག
རྩེད་འགྲན
རིག་རྩལ
གྱོན་རུང
Cupola Furnace: the Common Foundry Cupola with a Drop Bottom (Bolland, 1893)
Forge

བཟོས་མཁན

Forge

4. སྤྱི་ཟླ་བཅུ་གཅིག་པ 2026NO
༠
༠
༠
༡
༠

Cupola Furnace: the Common Foundry Cupola with a Drop Bottom (Bolland, 1893)

The founder's 'common cupola': an upright steel shell lined with firebrick, standing on four columns over a drop bottom, with a wind-box round it feeding the tuyeres and a charging door high up. Coke and pig iron go in at the top in layers; blast at the tuyeres melts the iron, which runs out at the spout. Variable: the inside diameter, 24 to 84 in, which sets height, tuyeres, blower and charges. Fig. 9's 36 in cupola is 12 ft to the charging hole and takes 840 lb coke and 2520 lb iron on the bed, then 302 lb coke and 2718 lb iron per charge. Source: S. Bolland, The Iron Founder Supplement (1893), pp. 34-54. Unknown: shell plate and brick sizes. Picture: Fig. 9 of the book.
ཆེས་མཁས་པ
Unknown

ལམ་སྟོན

1

Size the cupola

Choose the inside diameter from the iron needed per hour: 10 tons in two hours (about 10,760 lb an hour) needs 48 in; 6 tons, 40 in. Make it tall enough that the gas burns before it escapes: a 50 in cupola is 14 ft from the base to the bottom of the charging hole, Fig. 9's 36 in one 12 ft. Above 60 in, keep 60 in at the tuyeres and widen above them, since the blast cannot reach the middle of a wider stock.

ལག་ཆས་དགོས་མཁོ:

མ་ཤེས་པའི་ཚད།མ་ཤེས་པའི་ཚད།
2

Build the shell, columns and drop bottom

Build a steel shell with a charging hole and door, standing on four columns. Close the bottom with swing doors on a central prop, so the whole contents can be dropped at the end of a heat. Put a slag hole a little below the tuyeres and a spout at the bottom. Ours: mild steel plate, iron castings for the bottom doors. Not given: plate thickness.

གོམ་པ་འདིའི་རྫས་རིགས:

ལྕགས་འཇམ་གྱི་ཤོག་ལེབ་སྟུག།ལྕགས་འཇམ་གྱི་ཤོག་ལེབ་སྟུག།1 shell, charging door
ལྕགས་བླུགས་ཀྱི་ཅ་ལལྕགས་བླུགས་ཀྱི་ཅ་ལ1 drop-bottom doors
མ་ཤེས་པའི་ལྕགས་རིགས།མ་ཤེས་པའི་ལྕགས་རིགས།1 columns, prop, spout

ལག་ཆས་དགོས་མཁོ:

ཨག་ཀི་གློག་འཕྲུལ་བཙག་འཕྲུལ།ཨག་ཀི་གློག་འཕྲུལ་བཙག་འཕྲུལ།
མ་ཤེས་པའི་ཚད།མ་ཤེས་པའི་ཚད།
3

Fit the tuyeres and wind-box

Ring the cupola with a wind-box feeding the tuyeres, with a main blast pipe sized from the table (good for runs up to 100 ft). Tuyere area grows with the diameter: a 24 in cupola needs the area of 1 1/2 round 6 in tuyeres (or two flat ones 10 1/2 x 2 in), a 60 in about 13 1/2 (or eight flat 16 1/2 x 3 in), an 84 in 31 (or sixteen flat 16 x 3 1/2 in). Never reduce the tuyere area. A 42 in cupola takes a No. 3 Root blower and a 6 h.p. engine.

གོམ་པ་འདིའི་རྫས་རིགས:

ལྕགས་འཇམ་གྱི་ཤོག་ལེབ་སྟུག།ལྕགས་འཇམ་གྱི་ཤོག་ལེབ་སྟུག།1 wind-box
མ་ཤེས་པའི་ལྕགས་རིགས།མ་ཤེས་པའི་ལྕགས་རིགས།1 tuyeres, blast pipe

ལག་ཆས་དགོས་མཁོ:

ཨག་ཀི་གློག་འཕྲུལ་བཙག་འཕྲུལ།ཨག་ཀི་གློག་འཕྲུལ་བཙག་འཕྲུལ།
རླུང་འཕུ་འཕྲུལ་ཆས།རླུང་འཕུ་འཕྲུལ་ཆས།
4

Line it with firebrick

Line the shell with firebrick, every brick rubbed well down on the next and fitting the shell closely, set in mortar of the same nature as the bricks. A good lining lasts one to two years if the melter mends it each morning with thin coats of daubing, keeping its first shape. Ours: fireclay bricks and refractory clay mortar.

གོམ་པ་འདིའི་རྫས་རིགས:

མེ་ཐེག་འཇིམ་པའི་ས་ཕགམེ་ཐེག་འཇིམ་པའི་ས་ཕག1 lining
མེ་བཟོད་འཇིམ་གྱི་ཨར་གཅལམེ་བཟོད་འཇིམ་གྱི་ཨར་གཅལ1 setting and daubing

ལག་ཆས་དགོས་མཁོ:

རྡོ་བཟོ་བའི་སྐྱོགས།རྡོ་བཟོ་བའི་སྐྱོགས།
5

Make the bed and melt

Ram a sand bottom so it lies about 10 in below the tuyeres. Lay the fuel bed, about 22 in of coke above the tuyeres (840 lb in Fig. 9's 36 in cupola), and the first iron (2520 lb), then alternate charges of coke and iron (302 lb and 2718 lb). Blow: about 30,000 cubic feet of air melts a ton of iron. On long heats flux with white marble chips and draw the slag off at the slag hole. At the end, drop the bottom.

ལག་ཆས་དགོས་མཁོ:

བྱེ་མ།བྱེ་མ།
ལྕགས་བཟོའི་སོལ་བ།ལྕགས་བཟོའི་སོལ་བ།
ལྕགས་རྒྱུ་གོང་བུ།ལྕགས་རྒྱུ་གོང་བུ།
རླུང་འཕུ་འཕྲུལ་ཆས།རླུང་འཕུ་འཕྲུལ་ཆས།

རྫས་རིགས

5

ལག་ཆས་དགོས་མཁོ

7

བིལུ་པིརིན་ཊི་འདི་གིས་བཟོ་མི

CC0 སྤྱི་དབང

བིལུ་པིརིན་ཊི་འདི་CC0 འོག་བཀྲམས་ཡོད། ཁྱེད་རང་གིས་ཆོག་མཆན་མ་བཞེས་པར་ཕབ་ལེན་དང་བཟོ་བཅོས། བགོ་བཤའ། དགོས་མཁོ་གང་ལའང་བཀོལ་སྤྱོད་བྱས་ཆོག

བཟོ་མཁན་ལ་རྒྱབ་སྐྱོར་བྱེད་པའི་ཆེད་ཁོང་ཚོའི་བིལུ་པིརིན་ཊི་བརྒྱུད་ཐོན་སྐྱེད་ཉོ། བཟོ་མཁན་གྱིས བཟོ་མཁན་གྱི་ཁེ་ཕོགས ཚོང་པས་གཏན་འཁེལ་བྱས་པ། ཡང་ན་བིལུ་པིརིན་ཊི་འདིའི་པར་གསར་བཟོས་ཏེ་ཁྱེད་རང་གི་བིལུ་པིརིན་ཊི་ནང་མཐུད་སྦྲེལ་བྱས་ཏེ་ཡོང་སྒོ་བགོ་བཤའ་བྱེད།

གྲོས་བསྡུར

(0)

ནང་འཛུལ གྲོས་བསྡུར་ནང་མཉམ་ཞུགས་ཆེད

བསམ་ཚུལ་ཚུ་ཐོབ་བཞིན...