همکاری
هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنی‌ها
Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)
Tex

ایجاد شده توسط

Tex

13. نوامبر 2026FO
۶
۰
۰
۰
۰

Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)

A breastplate stops a riding saddle sliding backwards, as a crupper stops it sliding forwards. This is the hunting saddle breastplate from Paul N. Hasluck's Saddlery (1904): two rounded side straps from the shoulders to a ring at the chest, a cross strap over the neck, two small buckle straps to the saddle staples, and a strap between the forelegs to the girth. Every size is his.
پیشرفته
About 1 day

دستورالعمل‌ها

1

His sizes in centimetres

در حال بارگذاری دفترچهٔ Jupyter…
2

Read Saddlery, ch. V

"Breastplates (Fig. 10) are made for hunting saddles to prevent them falling backwards, just as the crupper keeps them from advancing too far."
3

Get the rings and buckles

You need one 1-1/2 in covered ring, two 1 in covered rings, two 5/8 in covered buckles and one 1 in covered buckle.

مواد مورد نیاز این مرحله:

حلقهٔ چرم‌پوشحلقهٔ چرم‌پوش3 قطعه
سگک چرم‌پوشسگک چرم‌پوش3 قطعه

ابزارهای مورد نیاز:

متر نواریمتر نواری
4

Make the two side straps

Cut two side straps 7/8 in wide and 2 ft long when turned over the rings at each end. Round the top on the groove board, stuffing it with strands of soft cord. Stitch them along both sides very finely with silk cotton or linen thread, putting a 1 in ring at one end of each and both other ends into the 1-1/2 in ring. Polish the edges well after stitching.

مواد مورد نیاز این مرحله:

چرم یراقچرم یراق1 قطعه
بندبند1 قطعه
نخ کتاننخ کتان1 قطعه
موم زنبور عسلموم زنبور عسل1 قطعه
حلقهٔ چرم‌پوشحلقهٔ چرم‌پوش3 قطعه

ابزارهای مورد نیاز:

کارد چرم‌بریکارد چرم‌بری
تختهٔ شیاردارتختهٔ شیاردار
درفشدرفش
دو سوزن سراجیدو سوزن سراجی
گیره دوخت چرمگیره دوخت چرم
صیقل لبهٔ چرمصیقل لبهٔ چرم
متر نواریمتر نواری
5

Make the cross strap

Cut a 1-3/8 in strap to be 10 in long when bent over the rings at each end; shave the ends and prick the sides finely like the shoulder piece. Cut another piece 9-1/4 in long when bent for the rings, 7/8 in wide at both ends and widening gradually to 1-3/4 in in the centre. Put the chapes in the 1 in rings and stitch both pieces together.

مواد مورد نیاز این مرحله:

چرم یراقچرم یراق1 قطعه
نخ کتاننخ کتان1 قطعه
موم زنبور عسلموم زنبور عسل1 قطعه

ابزارهای مورد نیاز:

کارد چرم‌بریکارد چرم‌بری
قلم کوک چرمقلم کوک چرم
درفشدرفش
دو سوزن سراجیدو سوزن سراجی
گیره دوخت چرمگیره دوخت چرم
متر نواریمتر نواری
6

Make the two buckle straps

Make two 5/8 in straps 2 ft long, one end prepared for the buckle, the other narrowed; edge, rub and crease them with a hot checker. Put one in each 1 in ring to within 3 in of the buckle. Double the 3 in length with the buckle on top and make two loops between the two leathers. Stitch from the ring along both sides to the buckle, fastening the loops at the same time. Finish the edges of the stitched part and make seven or eight holes in the points.

مواد مورد نیاز این مرحله:

چرم یراقچرم یراق1 قطعه
سگک چرم‌پوشسگک چرم‌پوش2 قطعه
نخ کتاننخ کتان1 قطعه
موم زنبور عسلموم زنبور عسل1 قطعه

ابزارهای مورد نیاز:

کارد چرم‌بریکارد چرم‌بری
ابزار پخ‌زنی لبهابزار پخ‌زنی لبه
صیقل لبهٔ چرمصیقل لبهٔ چرم
ابزار تاخورابزار تاخور
مشعل پروپانمشعل پروپان
قالب حلقهٔ تسمهقالب حلقهٔ تسمه
درفشدرفش
دو سوزن سراجیدو سوزن سراجی
منگنهٔ سوراخ‌کن چرممنگنهٔ سوراخ‌کن چرم
7

Make the girth strap

Cut a strap 1-1/4 in wide and 3 ft long. Narrow it to 1 in at 1 ft from the bend at the ring and turn it down for the 1 in buckle at the narrow end; edge, rub and crease it, then put the buckle in the reverse way. Cut eight or nine holes, beginning about 8 in from the buckle, and buckle the strap back on itself to make a loop for the girth (bellyband) to pass through.

مواد مورد نیاز این مرحله:

چرم یراقچرم یراق1 قطعه
سگک چرم‌پوشسگک چرم‌پوش1 قطعه
نخ کتاننخ کتان1 قطعه
موم زنبور عسلموم زنبور عسل1 قطعه

ابزارهای مورد نیاز:

کارد چرم‌بریکارد چرم‌بری
ابزار پخ‌زنی لبهابزار پخ‌زنی لبه
صیقل لبهٔ چرمصیقل لبهٔ چرم
ابزار تاخورابزار تاخور
مشعل پروپانمشعل پروپان
درفشدرفش
دو سوزن سراجیدو سوزن سراجی
منگنهٔ سوراخ‌کن چرممنگنهٔ سوراخ‌کن چرم
8

Fit the safe

Put the other end of the girth strap in the 1-1/2 in ring. Cut a safe to go under it, running up under the ring round the top part and down about 3-1/2 in below the bend, narrowing towards the end almost to the width of the strap. Crease the safe and place it under the chape and ring; stitch it down on both sides with a fancy stitch in the centre. Line the safe with chamois or very thin buff, stitched in all round, stuff a little flock through the opening at the bottom, and close the opening with fancy stitching such as an arrow point. He adds that it can be made of single leather without lining, only the bends being stitched.

مواد مورد نیاز این مرحله:

چرم یراقچرم یراق1 قطعه
چرم جیرچرم جیر1 قطعه
پشم پرکنپشم پرکن1 قطعه
نخ کتاننخ کتان1 قطعه
موم زنبور عسلموم زنبور عسل1 قطعه

ابزارهای مورد نیاز:

کارد چرم‌بریکارد چرم‌بری
ابزار تاخورابزار تاخور
مشعل پروپانمشعل پروپان
درفشدرفش
دو سوزن سراجیدو سوزن سراجی
گیره دوخت چرمگیره دوخت چرم
9

Put it on the horse

The long side straps run down from the shoulder to the chest, and the short cross strap passes over the neck at the top. The two small straps buckle to the staples in front of the saddle, and the girth strap runs from the big ring under the belly between the forelegs to the girth.
10

Troubleshooting

Breastplate troubleshooting.

Flow

Loading...
11

History and honest limits

From **Saddlery**, edited by Paul N. Hasluck, David McKay, 1904 (archive.org saddlery00hasl), chapter V, "Saddle Cruppers, Breastplates, and Other Accessories", breastplates, pp. 41-44, Fig. 10; every fraction was read on the scan. He says the cross strap is pricked "like the shoulder piece" without describing a shoulder piece; check the cross strap against Fig. 10. The crupper, martingale, girths, stirrup leathers and saddle cloths of the same chapter are not made here. The tools and metric figures are ours.

مواد

8

ابزارهای لازم

13

این نقشه می‌سازد

CC0 مالکیت عمومی

این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.

با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت می‌کند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

بحث و گفتگو

(0)

ورود برای شرکت در بحث

در حال بارگذاری نظرات...