កិច្ចសហប្រតិបត្តិការ
សិល្បៈ
សម្រស់ និង សុខុមាលភាព
សិប្បកម្ម
វប្បធម៌ និង ប្រវត្តិសាស្ត្រ
ការកម្សាន្ត
បរិស្ថាន
ម្ហូប និង ភេសជ្ជៈ
វិស្វកម្មបញ្ច្រាស
វិទ្យាសាស្ត្រ
កីឡា
បច្ចេកវិទ្យា
ប្រដាប់ដែលស្លៀក
Brick Smith's Hearth: Stone Base, Firebrick Top in an Iron Rim, a Cannon-Shot Tuyere and a Slake Trough (Edwinson, 1886)
Forge

បង្កើតដោយ

Forge

14. វិច្ឆិកា 2026NO
8
0
0
0
0

Brick Smith's Hearth: Stone Base, Firebrick Top in an Iron Rim, a Cannon-Shot Tuyere and a Slake Trough (Edwinson, 1886)

The fixed smith's hearth George Edwinson told Amateur Work readers to build (1886): stone below, firebrick in fireclay on top, every course bound with hoop iron, a 4 in. iron rim forming the hearth pan, a fire back and tuyere made from a 1 in. plate and a bored 14-pounder iron shot, a slanting flue, a 10 x 10 x 22 in. slake trough, and a clinker floor.
មធ្យម
Two to three days of building

ការណែនាំ

1

His sizes

កំពុងផ្ទុកសៀវភៅ Jupyter…
2

Read Edwinson

"The foundation of this structure up to within one foot of the top may be of stone, but the finishing courses should be of firebrick."
3

Build the base

Build the hearth in stone up to 1 ft (30 cm) below the top, binding every course with pieces of hoop iron. Leave an arch at the back for the coal pit and the blast pipe (figs. 4, 5). Overall size is ours: fit it to your shop.

សម្ភារៈសម្រាប់ជំហាននេះ៖

ដុំថ្មដុំថ្ម1 ដុំ
កង់ដែកកង់ដែក1 ដុំ
ដីឥដ្ឋធន់នឹងភ្លើងដីឥដ្ឋធន់នឹងភ្លើង1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ស្លាបព្រារៀបថ្មស្លាបព្រារៀបថ្ម
នីវ៉ូទឹកនីវ៉ូទឹក
4

Make the fire back and tuyere

Bore a 3/4 in. hole through a 14-pounder iron shot and open it to a 1 in. taper on one side. Cut and countersink a hole in a 1 in. iron plate to take a third of the shot, and drill four 1/2 in. holes to bolt the plate through the wall with nuts and fish plates. (Or buy a fire back and tue-iron.)

សម្ភារៈសម្រាប់ជំហាននេះ៖

គ្រាប់ដែក (តុល្យភាព)គ្រាប់ដែក (តុល្យភាព)1 ដុំ
បន្ទះដែកបន្ទះដែក1 ដុំ
ការប្រមូលផ្ដុំប៊ូឡុងប្រាំមួយជ្រុងការប្រមូលផ្ដុំប៊ូឡុងប្រាំមួយជ្រុង1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ម៉ាស៊ីនចោះឈរម៉ាស៊ីនចោះឈរ
ឡជាងដែកឡជាងដែក
ញញួរញញួរ
5

Firebrick top and back

Lay the top courses and the back wall round the tuyere in firebrick bedded and jointed with fireclay, still binding each course with hoop iron. Build in the fire back with the shot as the tuyere, and leave a slanting flue hole just above it (fig. 5).

សម្ភារៈសម្រាប់ជំហាននេះ៖

ឥដ្ឋធន់នឹងភ្លើងឥដ្ឋធន់នឹងភ្លើង1 ដុំ
ដីឥដ្ឋធន់នឹងភ្លើងដីឥដ្ឋធន់នឹងភ្លើង1 ដុំ
កង់ដែកកង់ដែក1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ស្លាបព្រារៀបថ្មស្លាបព្រារៀបថ្ម
នីវ៉ូទឹកនីវ៉ូទឹក
6

Fit the slake trough

Before the last course, set in a water trough 10 in. deep and wide and 22 in. long, of sheet iron, cast iron or stone, inside the rim line; bolt a sheet-iron one to the rim. A sheet-iron division riveted across gives a coal trough too.

សម្ភារៈសម្រាប់ជំហាននេះ៖

សន្លឹកដែកថែបទន់សន្លឹកដែកថែបទន់1 ដុំ
ដែកគោលដែកដែកគោលដែក1 ដុំ
ទឹកទឹក1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ម៉ាស៊ីនចោះឈរម៉ាស៊ីនចោះឈរ
ញញួរញញួរ
7

Bind with the rim

Bind the top course with a rim of 1/4 x 4 in. iron, half below the brick edge and half above it to make the hearth pan, its ends bolted to the back wall with 3/8 in. bolts built into the brickwork.

សម្ភារៈសម្រាប់ជំហាននេះ៖

បន្ទះដែកបន្ទះដែក1 ដុំ
ការប្រមូលផ្ដុំប៊ូឡុងប្រាំមួយជ្រុងការប្រមូលផ្ដុំប៊ូឡុងប្រាំមួយជ្រុង1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ឡជាងដែកឡជាងដែក
ទាំងជល់ (កំណាត់ដែក)ទាំងជល់ (កំណាត់ដែក)
ញញួរញញួរ
ម៉ាស៊ីនចោះឈរម៉ាស៊ីនចោះឈរ
8

Connect the blast

Bring the pipe from a fan or bellows under the arch to the back of the tue-iron. He reckons about 150 cu ft (4.2 m3) of air a minute for a welding heat: a 9 in. fan at about 360 rpm or a double-action bellows.

ឧបករណ៍ដែលត្រូវការ៖

ម៉ាស៊ីនផ្លុំខ្យល់ម៉ាស៊ីនផ្លុំខ្យល់
9

Lay the floor

Ram wetted smiths', foundry or boiler clinkers sprinkled with a little Portland cement hard and level, with a thin layer of smithy cinder ashes beaten on top. Stone or ordinary concrete floors misbehave when hot iron is dropped on them.

សម្ភារៈសម្រាប់ជំហាននេះ៖

ស៊ីម៉ងត៍ព័រតឡង់ស៊ីម៉ងត៍ព័រតឡង់1 ដុំ
ទឹកទឹក1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ញញួរញញួរ
10

Troubleshooting

Hearth troubleshooting.

Flow

Loading...
11

History and honest limits

From George Edwinson, "Smithing and Forging" I, **Amateur Work, Illustrated**, vol. V (1886), pp. 161-162 and figs. 2, 4, 5 (checked on the archive.org scan amateurworkillus05lond). He gives no overall hearth size; that and the metric figures and tools are ours.

សម្ភារៈ

11

ឧបករណ៍ចាំបាច់

7

ប្លង់ពាក់ព័ន្ធ

ប្លង់ទាំងនេះចែករំលែកចំណេះដឹង — បច្ចេកទេស សម្ភារៈ ឬគោលការណ៍

CC0 សាធារណៈ

ប្លង់នេះត្រូវបានចេញផ្សាយក្រោម CC0។ អ្នកមានសិទ្ធិចម្លង កែប្រែ ចែកចាយ និងប្រើប្រាស់ដោយមិនចាំបាច់សុំអនុញ្ញាត។

គាំទ្រអ្នកបង្កើតដោយទិញផលិតផលតាមរយៈប្លង់របស់ពួកគេ ដែលពួកគេទទួលបាន កម្រៃជើងសារអ្នកបង្កើត កំណត់ដោយអ្នកលក់ ឬបង្កើតកំណែថ្មីនៃប្លង់នេះ ហើយបញ្ចូលជាការតភ្ជាប់ក្នុងប្លង់របស់អ្នកដើម្បីចែករំលែកចំណូល។

ការពិភាក្សា

(0)

ចូល ដើម្បីចូលរួមពិភាក្សា

កំពុងផ្ទុកមតិ...