예술
뷰티 및 웰니스
공예
문화 및 역사
엔터테인먼트
환경
음식 및 음료
역공학
과학
스포츠
기술
웨어러블
Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass
Charlie

작성자

Charlie

24. 9월 2026DE
23
0
0
0
0

Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass

Boiling a solution dry gives you everything that was dissolved in it, including the impurities. Letting it crystallise slowly gives you the substance you wanted and leaves most of the impurities in the liquid — because a growing crystal is fussy about what it lets in. So evaporating to dryness and crystallising are not two ways of doing the same job. The first is for recovering everything; the second is for purifying. Then there is the question of when it is actually DRY, which cannot be answered by looking. The answer is a measurement loop: dry, weigh, dry again, weigh again, and stop when the mass stops changing.
중급
3 hours

안내

1

Evaporate gently, and never to the last drop over heat

Use a wide, shallow evaporating dish rather than a beaker: evaporation happens at the surface, so the area is what sets the speed, and a wide dish is faster at a much lower temperature. Stop while a little liquid remains and let the rest go at room temperature. Once the liquid is nearly gone there is nothing left to absorb the heat, the solid overheats in seconds, and it spits, decomposes or bakes onto the dish. A steam bath or a hot plate on a low setting is better than a flame for anything that matters. Direct flame heats one spot far above the boiling point of the solution, and many substances that survive 100 degrees do not survive that.

이 단계의 재료:

증류수증류수1 리터
염화나트륨(소금)염화나트륨(소금)1 개

필요한 도구:

증발 접시증발 접시
전열판(핫플레이트)전열판(핫플레이트)
시계접시시계접시
2

Crystallise slowly, and crystallise on purpose

Dissolve the solid in the smallest volume of hot solvent that will take it, then let it cool UNDISTURBED. Slow cooling grows few, large, pure crystals; rapid cooling or stirring gives a mass of tiny ones that trap the mother liquor and everything dissolved in it. If nothing appears, it is usually because there is too much solvent or because there is no nucleus to start on. Boil a little solvent off, scratch the inside of the glass with a rod at the surface, or add one seed crystal. Then filter the crystals off cold and rinse them with a SMALL amount of ICE-COLD solvent. Rinsing with warm solvent dissolves the product you just spent an hour growing, which is the most disheartening way to lose a yield.

이 단계의 재료:

증류수증류수1 리터
황산구리 오수화물(CuSO4·5H2O)황산구리 오수화물(CuSO4·5H2O)1 개

필요한 도구:

유리 비커유리 비커
유리 젓개유리 젓개
뷰흐너 깔때기(자기)뷰흐너 깔때기(자기)
여과지여과지
3

Dry to constant mass, which is a measurement not a judgement

Jupyter 노트북 불러오는 중…

이 단계의 재료:

염화나트륨(소금)염화나트륨(소금)1 개

필요한 도구:

건조 가마건조 가마
유리 건조기유리 건조기
정밀 저울정밀 저울
데스크톱 컴퓨터데스크톱 컴퓨터
4

Work out the yield, and be honest about it

Percentage yield is what you got divided by what the equation says you could have got. Both numbers have to be real: the mass actually recovered and dried, and the theoretical mass calculated from the LIMITING reagent. Yields above 100% mean the product is not dry, or it has picked up something. That is worth treating as a fault rather than a bonus, because a wet product weighs more and is worth less. Record where the losses went, in the notebook: left in the mother liquor, stuck to the filter paper, lost in the rinse, spilled. Those lines are what make the next attempt better, and a yield with no explanation attached is a number nobody can improve.

필요한 도구:

정밀 저울정밀 저울
계산기계산기

재료

3

필요 도구

12

CC0 퍼블릭 도메인

이 블루프린트는 CC0로 공개되었습니다. 어떤 목적으로든 자유롭게 복사, 수정, 배포 및 사용할 수 있습니다.

제품 구매를 통해 메이커를 지원하세요. 판매자가 설정한 메이커 커미션 을 받거나, 이 블루프린트의 새로운 반복을 만들어 연결로 포함시킬 수 있습니다.

토론

(0)

로그인 하여 토론에 참여하세요

댓글 로딩 중...