ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Bell Telephone
Ed

สร้างโดย

Ed

28. กรกฎาคม 2026FI
1
0
0
0
0

Bell Telephone

The telegraph could send a click. Sending a voice is a different problem entirely: speech is a continuously varying pressure wave, and a click is a switch. You cannot build a voice out of on and off, however fast you go.

The answer is to stop switching and start varying. A membrane moves with the sound pressure, that motion varies a current continuously, and at the far end the varying current pulls a second membrane through the same motion. Nothing is coded. The wire carries an electrical analogue of the sound wave — which is where the word analogue comes from.

The patent is titled "Improvement in Telegraphy", not telephone. US Patent 174,465, granted to Alexander Graham Bell on 7 March 1876 — arguably the most valuable and most litigated patent ever issued, and one whose priority is still argued about.

ระดับกลาง
6 hours

คำแนะนำ

1

Read US 174,465 and note the title

It is called "Improvement in Telegraphy". Bell was funded to build a multiplexed telegraph; the telephone emerged from that work and the paperwork never caught up.

เครื่องมือที่ต้องใช้:

Notebook and PencilNotebook and Pencil
2

Prove a switch cannot carry a voice

Wire a buzzer through a key and try to say a word with it. You can send code arbitrarily fast and it still is not speech — the signal has no amplitude information.

3

Wind a coil on a soft iron core

Wind several hundred turns of fine enamelled wire onto an iron core. Two of these, identical, are the whole instrument.

วัสดุสำหรับขั้นตอนนี้:

Enamelled Copper WireEnamelled Copper Wire50 เมตร
4

Fit a permanent magnet behind the core

Mount a magnet against the core so the coil sits in a steady field. Without a bias magnet the output doubles in frequency and the voice is unrecognisable.

วัสดุสำหรับขั้นตอนนี้:

Neodymium MagnetNeodymium Magnet2 ชิ้น
5

Cut a thin iron diaphragm

Cut a disc of thin ferrous sheet to sit just clear of the core. It must be thin enough to move with a voice and stiff enough to return.

วัสดุสำหรับขั้นตอนนี้:

Mild Steel SheetMild Steel Sheet1 แผ่น
6

Set the air gap as small as you dare

Under a millimetre, without touching. Sensitivity falls off sharply with gap — this single clearance decides whether the thing works at all.

เครื่องมือที่ต้องใช้:

Measuring RulerMeasuring Ruler
7

Clamp the diaphragm only at its rim

Hold it around the edge so the centre is free to move. Clamped anywhere else it becomes a plate, not a membrane.

8

Build the second unit identically

Make an exact copy. In Bell's design the transmitter and receiver are the SAME device — the effect runs in both directions.

9

Wire the two coils in a single loop

Connect them with two wires and nothing else. No battery, no amplifier — the speaker's voice supplies all the energy.

วัสดุสำหรับขั้นตอนนี้:

Copper WireCopper Wire20 เมตร
10

Speak loudly into one and listen at the other

Press the second unit to your ear. It is faint and it is unmistakably a voice — this is a magneto telephone and it needs no power source.

11

Understand where the current comes from

The moving iron diaphragm changes the magnetic flux through the coil and induces a voltage — Faraday's law. Your voice is doing the generating.

12

Now build a carbon transmitter and compare

Fill a small chamber with carbon granules behind a diaphragm and pass a battery current through it. Pressure changes resistance, so the battery is modulated instead of the voice generating power.

วัสดุสำหรับขั้นตอนนี้:

CharcoalCharcoal50 ก.
13

Measure how much louder the carbon version is

It is dramatically louder, because it is an amplifier — the voice controls battery energy rather than supplying it. Edison's carbon transmitter, not Bell's, is what made telephony practical over distance.

14

Lengthen the line and find the limit

Add wire and re-test. The magneto version fades quickly; the carbon version carries much further. Line loss is why the network needed loading coils and later repeaters.

15

Compendium — an analogue, not a code

The patent. US 174,465, "Improvement in Telegraphy", granted 7 March 1876 to Alexander Graham Bell. Its commercial value was extraordinary and it was litigated more than almost any patent in history — the Bell company fought some six hundred challenges and won essentially all of them. Bell's famous first intelligible sentence to Thomas Watson came three days after the grant, on 10 March 1876.

The priority dispute is real and unresolved. Elisha Gray filed a caveat describing a liquid transmitter at the same patent office on the same day, 14 February 1876. Antonio Meucci had demonstrated voice-over-wire devices in New York from the 1850s but could not afford to maintain a patent caveat; in 2002 the US House of Representatives passed a resolution recognising his contribution. Johann Philipp Reis built a working sound transmitter in Germany in 1861. Bell got the patent and built the industry; the claim that he was the sole originator of the idea does not survive contact with the record, and it is worth stating that plainly rather than smoothing it over.

Two ways to modulate a wire. Bell's magneto instrument is a generator: a moving iron diaphragm alters the flux through a coil and induces a current directly, so the sound energy of the voice IS the signal energy. It needs no battery and it is symmetrical — the same unit works as microphone or earpiece. A carbon transmitter is instead a variable resistor: sound pressure squeezes carbon granules, resistance falls, and a battery current is modulated. That is amplification, and it delivered vastly more signal power to the line. Edison patented the carbon transmitter and it, combined with Bell's receiver, is what the telephone network actually ran on for a century.

Why the bias magnet matters. An iron diaphragm in front of a plain electromagnet is attracted regardless of current direction, so it responds twice per cycle and the output is distorted to double frequency. Adding a permanent magnet biases the system so the varying field adds to or subtracts from a steady one, and the diaphragm follows the waveform linearly. It is the same reason a loudspeaker has a permanent magnet, and the same class of trick as biasing an amplifier — build the signal on top of a steady offset so the response stays linear.

วัสดุ

5

เครื่องมือที่จำเป็น

2

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...