ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Charcoal Air Furnace for Crucibles, Drawn by a Chimney
Forge

สร้างโดย

Forge

14. ตุลาคม 2026NO
23
0
0
0
0

Charcoal Air Furnace for Crucibles, Drawn by a Chimney

The chemist's furnace for melting in crucibles needs no bellows: a firebrick box closed on every side, air entering only under the grate, and a tall chimney to draw it through the burning charcoal. George Fownes (1856) describes it; a sliding damper in the flue sets the heat, from dull red upward. The picture: a 16th-century assay workshop woodcut with wind furnaces, one on a tripod, for melting silver in crucibles (Deutsche Fotothek).
ระดับกลาง
Two days, plus drying

คำแนะนำ

1

Fireclay mortar

Mix fireclay and fine sand with water to a stiff, smooth mortar (our mix: about one part clay to one of sand).

วัสดุสำหรับขั้นตอนนี้:

ดินทนไฟดินทนไฟ10 กก.
ทรายละเอียดทรายละเอียด10 กก.
น้ำน้ำ8 ลิตร

เครื่องมือที่ต้องใช้:

ถังถัง
เสียมมือเสียมมือ
2

Ash pit and grate

Lay a level firebrick base and build a low ash pit with an opening at the front. Forge bars from wrought iron rod and set them across the top as the grate, a finger's width apart.

วัสดุสำหรับขั้นตอนนี้:

อิฐทนไฟอิฐทนไฟ20 ชิ้น
เส้นเหล็กดัดเส้นเหล็กดัด2 m

เครื่องมือที่ต้องใช้:

เสียมมือเสียมมือ
ระดับน้ำระดับน้ำ
เตาตีเหล็กของช่างตีเหล็กเตาตีเหล็กของช่างตีเหล็ก
ค้อนหัวลิ่มขวางค้อนหัวลิ่มขวาง
3

Fire box

Build a square box of firebricks on the grate, wide enough for a crucible with a hand's width of charcoal all round, and tall enough to cover it. Joint every brick thinly with the fireclay mortar.

วัสดุสำหรับขั้นตอนนี้:

อิฐทนไฟอิฐทนไฟ40 ชิ้น

เครื่องมือที่ต้องใช้:

เสียมมือเสียมมือ
ระดับน้ำระดับน้ำ
4

Flue, chimney and damper

Lead a flue out near the top into a tall chimney pipe. Fit an iron sliding plate across the flue as a damper. Close the top with a loose firebrick lid.

วัสดุสำหรับขั้นตอนนี้:

ท่อปล่องควันท่อปล่องควัน1 ชิ้น
แผ่นเหล็ก (ตีด้วยค้อน)แผ่นเหล็ก (ตีด้วยค้อน)1 ชิ้น

เครื่องมือที่ต้องใช้:

เสียมมือเสียมมือ
5

Dry and first fire

Let the mortar dry for days, then light a small charcoal fire and raise it slowly over an hour or two so the joints do not crack.

วัสดุสำหรับขั้นตอนนี้:

ถ่านไม้ถ่านไม้10 กก.

เครื่องมือที่ต้องใช้:

ถุงมือกันความร้อนถุงมือกันความร้อน
6

Draught from the chimney

กำลังโหลดสมุด Jupyter…
7

Limits

The principle and the damper are Fownes's; the sizes, the mortar mix and the draught formula's working figures are ours. Charcoal fires make carbon monoxide: work outdoors or under a good chimney.

วัสดุ

8
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง
  • 8 ลิตร
    ตัวยึดตำแหน่ง
  • 40 ชิ้น
    ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง
  • ตัวยึดตำแหน่ง

เครื่องมือที่จำเป็น

6

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...