SINING
BEAUTY AT WELLNESS
CRAFTS
KULTURA AT KASAYSAYAN
LIBANGAN
KAPALIGIRAN
PAGKAIN AT INUMIN
REVERSE ENGINEERING
AGHAM
ISPORTS
TEKNOLOHIYA
MGA WEARABLE
Electricity From the Wind: The Cube Law and a Rotor on a Dynamo
Volt

Nilikha ni

Volt

27. Setyembre 2026SE
5
0
0
0
0

Electricity From the Wind: The Cube Law and a Rotor on a Dynamo

For a thousand years windmills ground grain and pumped water. In the winter of 1887–88 Charles F. Brush put one to a new job in the back garden of his house in Cleveland, Ohio: a 17-metre rotor of 144 cedar blades turning a dynamo that charged a cellar full of batteries — electricity from the wind. Everything about a wind generator follows from one relation: the power in the wind goes with the cube of its speed and the square of the rotor's diameter. That is why turbines grew huge and why their sites are chosen with such care. This rung builds a small wind generator from a hobby motor and a printed rotor, measures its power in front of a fan at several wind speeds, and checks the cube law.
Baguhan
About 4 hours

Mga Tagubilin

1

The cube law

Naglo-load ng Jupyter notebook…
2

Build a small wind generator

A small permanent-magnet DC motor is also a generator: turn its shaft and it makes a voltage proportional to speed. Print a three-bladed rotor 300 mm across in PETG, with a hub that presses onto the motor shaft, each blade twisted — steep near the hub, flatter towards the tip — because the tip moves faster through the air than the root. Mount the motor on a dowel mast clamped to a plywood base, with the rotor facing the fan. Wire the motor's terminals to a 330 Ω resistor as a load, with the multimeter across it. Add an LED in series if you want to see it light.

Mga materyales para sa hakbang na ito:

Hobby Motor - GearHobby Motor - Gear1 piraso
PETG filamentPETG filament60 g
Mga tarugong matigas na kahoyMga tarugong matigas na kahoy1 set
Plantsa ng playwudPlantsa ng playwud1 pilyego
Risistor na 330 ohmRisistor na 330 ohm1 piraso
LED na 5 mmLED na 5 mm1 piraso
Mga Jumper WireMga Jumper Wire1 set

Mga kailangang kasangkapan:

Limbagang 3D na FDMLimbagang 3D na FDM
Walang-Kableng BarenaWalang-Kableng Barena
Hanay ng Talim ng BarenaHanay ng Talim ng Barena
Set ng hex keySet ng hex key
3

Measure its power at three wind speeds

Stand the box fan 1.5 m away, facing the rotor. Measure the wind speed at the rotor with the anemometer before fitting the rotor, at each fan setting. Fit the rotor, run the fan, and read the voltage across the resistor once it is steady. The electrical power is **V² ÷ R**. Record wind speed and power for each fan setting. Plot power against wind speed cubed. It should be roughly a straight line — not exactly, because a small motor's own losses take a bigger share at low speed. Then divide your power by the notebook's power passing through a 0.3 m disc at the same wind speed. That ratio is your rotor's power coefficient, and the Betz rung shows the most it could ever be.

Mga kailangang kasangkapan:

Box fan (nababagong bilis)Box fan (nababagong bilis)
Panukat ng hangin na hawak-kamayPanukat ng hangin na hawak-kamay
MultimetroMultimetro
Panukat na TapePanukat na Tape
Digital na TakometroDigital na Takometro
4

History and context

**Charles F. Brush, Cleveland, Ohio, 1887–88** — a 17 m, 144-bladed rotor on a tower about 18 m (60 ft) high driving a 12 kW dynamo through step-up gearing, charging batteries that lit his house; it ran for some twenty years. Brush had already built the arc-lighting dynamo in this catalogue. No patent number is asserted here. In Denmark from 1891, **Poul la Cour** tested rotors in a wind tunnel of his own and found that fewer blades turning faster made better use of the wind than many slow ones — the direction every modern turbine took. **Honest limits.** The wind stops; a wind generator needs storage or another source behind it. Its output swings with the cube of a quantity that changes by the minute. And a large rotor is a serious hazard: it must be able to stop itself in a storm, as the Halladay windmill's governor in this catalogue already could.

Mga Materyales

7

Mga Kinakailangang Kasangkapan

9
Tinatayang Kabuuan
Ang binili ng gumawa. Ang mga materyales na walang presyo ay kukunin mo kung saan ka bibili.
$2.53

CC0 Pampublikong Domain

Ang blueprint na ito ay inilabas sa ilalim ng CC0. Malaya kang kumopya, magbago, mamahagi, at gumamit nang walang pahintulot.

Suportahan ang Maker sa pamamagitan ng pagbili ng mga produkto sa kanilang Blueprint Komisyon ng Maker itinakda ng mga Vendor, o lumikha ng bagong bersyon ng Blueprint na ito at isama bilang koneksyon sa iyong Blueprint upang ibahagi ang kita.

Talakayan

(0)

Mag-login upang sumali sa talakayan

Naglo-load ng mga komento...