Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)
Tex

Autor

Tex

13. listopad 2026FO
5
0
0
0
0

Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)

A breastplate stops a riding saddle sliding backwards, as a crupper stops it sliding forwards. This is the hunting saddle breastplate from Paul N. Hasluck's Saddlery (1904): two rounded side straps from the shoulders to a ring at the chest, a cross strap over the neck, two small buckle straps to the saddle staples, and a strap between the forelegs to the girth. Every size is his.
Zaawansowany
About 1 day

Instrukcje

1

His sizes in centimetres

Wczytywanie notatnika Jupyter…
2

Read Saddlery, ch. V

"Breastplates (Fig. 10) are made for hunting saddles to prevent them falling backwards, just as the crupper keeps them from advancing too far."
3

Get the rings and buckles

You need one 1-1/2 in covered ring, two 1 in covered rings, two 5/8 in covered buckles and one 1 in covered buckle.

Materiały do tego kroku:

Kółko obszyte skórąKółko obszyte skórą3 sztuk
Sprzączka obszyta skórąSprzączka obszyta skórą3 sztuk

Potrzebne narzędzia:

Miara zwijanaMiara zwijana
4

Make the two side straps

Cut two side straps 7/8 in wide and 2 ft long when turned over the rings at each end. Round the top on the groove board, stuffing it with strands of soft cord. Stitch them along both sides very finely with silk cotton or linen thread, putting a 1 in ring at one end of each and both other ends into the 1-1/2 in ring. Polish the edges well after stitching.

Materiały do tego kroku:

Skóra uprzężowaSkóra uprzężowa1 sztuka
SznurekSznurek1 sztuka
Nić lnianaNić lniana1 sztuka
Wosk pszczeliWosk pszczeli1 sztuka
Kółko obszyte skórąKółko obszyte skórą3 sztuk

Potrzebne narzędzia:

Nóż do skóryNóż do skóry
Deska z rowkamiDeska z rowkami
SzydłoSzydło
Dwie igły rymarskieDwie igły rymarskie
Kozioł rymarskiKozioł rymarski
Gładzik do krawędzi skóryGładzik do krawędzi skóry
Miara zwijanaMiara zwijana
5

Make the cross strap

Cut a 1-3/8 in strap to be 10 in long when bent over the rings at each end; shave the ends and prick the sides finely like the shoulder piece. Cut another piece 9-1/4 in long when bent for the rings, 7/8 in wide at both ends and widening gradually to 1-3/4 in in the centre. Put the chapes in the 1 in rings and stitch both pieces together.

Materiały do tego kroku:

Skóra uprzężowaSkóra uprzężowa1 sztuka
Nić lnianaNić lniana1 sztuka
Wosk pszczeliWosk pszczeli1 sztuka

Potrzebne narzędzia:

Nóż do skóryNóż do skóry
Przecinak do szycia skóryPrzecinak do szycia skóry
SzydłoSzydło
Dwie igły rymarskieDwie igły rymarskie
Kozioł rymarskiKozioł rymarski
Miara zwijanaMiara zwijana
6

Make the two buckle straps

Make two 5/8 in straps 2 ft long, one end prepared for the buckle, the other narrowed; edge, rub and crease them with a hot checker. Put one in each 1 in ring to within 3 in of the buckle. Double the 3 in length with the buckle on top and make two loops between the two leathers. Stitch from the ring along both sides to the buckle, fastening the loops at the same time. Finish the edges of the stitched part and make seven or eight holes in the points.

Materiały do tego kroku:

Skóra uprzężowaSkóra uprzężowa1 sztuka
Sprzączka obszyta skórąSprzączka obszyta skórą2 sztuk
Nić lnianaNić lniana1 sztuka
Wosk pszczeliWosk pszczeli1 sztuka

Potrzebne narzędzia:

Nóż do skóryNóż do skóry
Fazownik krawędziFazownik krawędzi
Gładzik do krawędzi skóryGładzik do krawędzi skóry
BigownicaBigownica
Palnik propanowyPalnik propanowy
Wzornik do szlufekWzornik do szlufek
SzydłoSzydło
Dwie igły rymarskieDwie igły rymarskie
Dziurkacz do skóryDziurkacz do skóry
7

Make the girth strap

Cut a strap 1-1/4 in wide and 3 ft long. Narrow it to 1 in at 1 ft from the bend at the ring and turn it down for the 1 in buckle at the narrow end; edge, rub and crease it, then put the buckle in the reverse way. Cut eight or nine holes, beginning about 8 in from the buckle, and buckle the strap back on itself to make a loop for the girth (bellyband) to pass through.

Materiały do tego kroku:

Skóra uprzężowaSkóra uprzężowa1 sztuka
Sprzączka obszyta skórąSprzączka obszyta skórą1 sztuka
Nić lnianaNić lniana1 sztuka
Wosk pszczeliWosk pszczeli1 sztuka

Potrzebne narzędzia:

Nóż do skóryNóż do skóry
Fazownik krawędziFazownik krawędzi
Gładzik do krawędzi skóryGładzik do krawędzi skóry
BigownicaBigownica
Palnik propanowyPalnik propanowy
SzydłoSzydło
Dwie igły rymarskieDwie igły rymarskie
Dziurkacz do skóryDziurkacz do skóry
8

Fit the safe

Put the other end of the girth strap in the 1-1/2 in ring. Cut a safe to go under it, running up under the ring round the top part and down about 3-1/2 in below the bend, narrowing towards the end almost to the width of the strap. Crease the safe and place it under the chape and ring; stitch it down on both sides with a fancy stitch in the centre. Line the safe with chamois or very thin buff, stitched in all round, stuff a little flock through the opening at the bottom, and close the opening with fancy stitching such as an arrow point. He adds that it can be made of single leather without lining, only the bends being stitched.

Materiały do tego kroku:

Skóra uprzężowaSkóra uprzężowa1 sztuka
IrchaIrcha1 sztuka
Wypełnienie wełnianeWypełnienie wełniane1 sztuka
Nić lnianaNić lniana1 sztuka
Wosk pszczeliWosk pszczeli1 sztuka

Potrzebne narzędzia:

Nóż do skóryNóż do skóry
BigownicaBigownica
Palnik propanowyPalnik propanowy
SzydłoSzydło
Dwie igły rymarskieDwie igły rymarskie
Kozioł rymarskiKozioł rymarski
9

Put it on the horse

The long side straps run down from the shoulder to the chest, and the short cross strap passes over the neck at the top. The two small straps buckle to the staples in front of the saddle, and the girth strap runs from the big ring under the belly between the forelegs to the girth.
10

Troubleshooting

Breastplate troubleshooting.

Flow

Loading...
11

History and honest limits

From **Saddlery**, edited by Paul N. Hasluck, David McKay, 1904 (archive.org saddlery00hasl), chapter V, "Saddle Cruppers, Breastplates, and Other Accessories", breastplates, pp. 41-44, Fig. 10; every fraction was read on the scan. He says the cross strap is pricked "like the shoulder piece" without describing a shoulder piece; check the cross strap against Fig. 10. The crupper, martingale, girths, stirrup leathers and saddle cloths of the same chapter are not made here. The tools and metric figures are ours.

Materiały

8

Wymagane narzędzia

13

Według tego planu powstaje

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...