İşbirliği
SANAT
GÜZELLİK & SAĞLIK
ZANAAT
KÜLTÜR & TARİH
EĞLENCE
ÇEVRE
YİYECEK & İÇECEK
TERS MÜHENDİSLİK
BİLİMLER
SPOR
TEKNOLOJİ
GİYİLEBİLİR ÜRÜNLER
Body Roller: Web Band With a Quilted, Flock-Stuffed Pad and Two Buckled Straps (Hasluck, Saddlery, 1904)
Tex

Oluşturan

Tex

13. Kasım 2026FO
6
0
0
0
0

Body Roller: Web Band With a Quilted, Flock-Stuffed Pad and Two Buckled Straps (Hasluck, Saddlery, 1904)

A body roller is buckled round a horse behind the withers to keep its rug or sheet in place. This is the two-strap roller from Paul N. Hasluck's Saddlery (1904): a 6 ft 2 in web band with a stuffed pad of two compartments, faced with hogskin, lined with serge, quilted with twenty small leather rounds, and fastened with two buckled straps. Every size is his. Rollers may be of worsted, linen, union, webbing or leather.
İleri
About 2 days

Talimatlar

1

The marks on the roller

Jupyter defteri yükleniyor…
2

Read Saddlery, ch. IX

"Body rollers are made of worsted, linen, union, webbing, or leather, with one, two, or three straps, a full-sized roller being 6 ft. 2 in. long."
3

Bind the ends and mark the pad

Cut the roller 6 ft 2 in long; the pad sits about 10 in from one point. Bind the short end near the pad with leather 1 in wide on each side, stitched with single thread. Bind the other end the same way, 1 in wide on the front, but line the girth for about 6 in below and stitch along the edge of the roller; raise a stitch over the edge of the leather without running through. With a lead pencil, mark a line across 10 in from the end without lining, a second line 1 ft away, and two more 5-1/4 in from each line, leaving a 1-1/2 in space between them.

Bu adım için malzemeler:

Kolan şeridiKolan şeridi1 adet
Tabaklanmış domuz derisiTabaklanmış domuz derisi1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet
Kurşun kalemKurşun kalem1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
BizBiz
İki saraç iğnesiİki saraç iğnesi
Saraç mengenesiSaraç mengenesi
Şerit MetreŞerit Metre
4

Cut the card, lining and facings

Cut stiff cardboard the width of the roller, reaching 1 in below each end line, and thin its edges. Cut white serge (basil or hogskin for a leather girth) to reach 2 in below the two end lines and 1/2 in wider on each side. Cut two hogskin facings 1 ft 4 in by 1-1/4 in, narrowed at the centre to a little less than half opposite the space between the inner lines; round the corners and cut slanting towards the ends until each is about 1/2 in wide at the point. Turn the serge down 1/4 in along its long edges and whip it to the facings along the shaped edge, centre to centre, with the full and narrow parts matching on each side.

Bu adım için malzemeler:

Yapıştırma mukavvaYapıştırma mukavva1 adet
Yün serjYün serj1 adet
Tabaklanmış domuz derisiTabaklanmış domuz derisi1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
MakasMakas
İki saraç iğnesiİki saraç iğnesi
Şerit MetreŞerit Metre
5

Make and set the straps

Cut two pieces of leather 2-1/4 in deep and the width of the roller and crease them along the long sides with a hot iron; cut two similar pieces of basil. Cut two strong 1-1/4 in brown leather straps 1 ft 6 in long, point one end, shave the other, crease them double and make eight holes in each. Put one basil piece underneath, level with the roller edges, reaching a little above the line nearer the short end. Place the straps within 1/4 in of that line, pointing towards the short end, and stitch them down firmly through roller and basil.

Bu adım için malzemeler:

Tabaklanmış domuz derisiTabaklanmış domuz derisi1 adet
Meşin (koyun derisi)Meşin (koyun derisi)1 adet
Koşum derisiKoşum derisi1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
Kıvırma aletiKıvırma aleti
Deri delme zımbasıDeri delme zımbası
BizBiz
İki saraç iğnesiİki saraç iğnesi
6

Build the pad

Place the hogskin end pieces on the ends of the pad, their upper edges about 1/8 in above the end lines, and the other basil piece under the end without straps; tack the basil down. Tack a creased piece 1-3/4 in wide across the centre to cover the two central lines, then tack the cardboard underneath, centred. The end piece at the strap end covers the stitched ends of the straps. Stitch the end pieces through roller and card along their upper cross lines and the ends of the centre piece at the edges, leaving the two central lines unstitched.

Bu adım için malzemeler:

Tabaklanmış domuz derisiTabaklanmış domuz derisi1 adet
Kalıba çekme çivisiKalıba çekme çivisi1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

ÇekiçÇekiç
Kıvırma aletiKıvırma aleti
BizBiz
İki saraç iğnesiİki saraç iğnesi
7

Line, bind and stuff

Put the serge lining and facing centre to centre on each side and whip the facing to the roller along both edges through web and card, the ends reaching just below the stitched end lines. Bind both edges with a thin hogskin strip about 1/2 in wide from end piece to end piece. Stitch the two centre lines through from side to side, making two compartments. Make two rows of stitches down through the leather between and close to the straps, and two at the other end. Stuff both sides firm and level with flock through the bottom opening, turn in the serge edge, and raise a stitch to hold the leather lining opposite the serge.

Bu adım için malzemeler:

Tabaklanmış domuz derisiTabaklanmış domuz derisi1 adet
Yün dolguYün dolgu1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
BizBiz
İki saraç iğnesiİki saraç iğnesi
8

Quilt the pad

Cut twenty small round or scalloped pieces of coloured roan or hogskin, a little smaller than a threepenny bit. Quilt five on each side of each part, twenty in all, in a perfectly straight line 1 in from the edge: drive the needle up from below, through the leather round, down again through it and the roller, and knot it below over a small tuft of coloured wool.

Bu adım için malzemeler:

Boyalı meşin (roan)Boyalı meşin (roan)1 adet
Boyalı yün iplikBoyalı yün iplik1 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
İki saraç iğnesiİki saraç iğnesi
9

Fit the buckles and loops

Cut two chapes for two 1-1/4 in buckles and two loops, and stitch the chapes with the outside of the buckles flush with the end of the roller, straight to the straps. Make a loop long enough to reach across the girth, stitched across at both ends and with two cross rows in the centre, leaving room for the two straps, about 6 in below the chapes. Block, crease and finish the loops; he puts a fancy stamp in the centre of each.

Bu adım için malzemeler:

Koşum derisiKoşum derisi1 adet
Dilli demir tokaDilli demir toka2 adet
Keten iplikKeten iplik1 adet
BalmumuBalmumu1 adet

Gerekli aletler:

Deri bıçağıDeri bıçağı
Kıvırma aletiKıvırma aleti
Köprü kalıp çubuğuKöprü kalıp çubuğu
BizBiz
İki saraç iğnesiİki saraç iğnesi
10

Troubleshooting

Body roller troubleshooting.

Flow

Loading...
11

History and honest limits

From **Saddlery**, edited by Paul N. Hasluck, David McKay, 1904 (archive.org saddlery00hasl), chapter IX, "Horse Clothing", body rollers, pp. 75-80, Figs. 31-32; every fraction was read on the scan. His wording on the end pieces is brief; check them against Figs. 31 and 32. The stallion roller, surcingle, sheets and hood are not made here. The thread, tools and metric figures are ours.

Malzemeler

14

Gerekli Aletler

10

CC0 Kamu Malı

Bu plan CC0 lisansıyla yayınlanmıştır. İzin almadan kopyalayabilir, değiştirebilir, dağıtabilir ve herhangi bir amaçla kullanabilirsiniz.

Planı üzerinden ürün satın alarak Maker'ı destekleyin, böylece Maker Komisyonu Satıcılar tarafından belirlenen komisyonu kazanırlar veya bu Planın yeni bir versiyonunu oluşturun ve gelir paylaşımı için kendi Planınıza bağlantı olarak ekleyin.

Tartışma

(0)

Giriş yapın tartışmaya katılmak için

Yorumlar yükleniyor...