Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО
Craftsman Leather Billfold: Two Cardboard Patterns, Silk Lining and Saddle-Stitched Waxed Silk (Boy Mechanic, 1919)
Tex

Створено

Tex

13. листопад 2026FO
12
0
0
0
0

Craftsman Leather Billfold: Two Cardboard Patterns, Silk Lining and Saddle-Stitched Waxed Silk (Boy Mechanic, 1919)

Livingston Haviland's billfold from The Boy Mechanic, Book 3 (1919): two leather body parts cut to stiff-cardboard patterns (13-1/4 and 8-3/16 by 4-1/4 in), lined with skiver or silk moire, folded into two card pockets and a money compartment, glued, and hand-sewn with heavy waxed silk 3/16 in from the edges.
Середній
About 1 day

Інструкції

1

His patterns in centimetres

Завантаження блокнота Jupyter…
2

Read The Boy Mechanic, Book 3

"The making of a billfold is easily within the range of an amateur in leather work, who will observe the instructions carefully." Seal, morocco, pigskin and ooze sheep are all satisfactory.
3

Cut the patterns and the leather

Cut two patterns of stiff cardboard (Fig. 1). Body part No. 1: 13-1/4 by 4-1/4 in, with fold lines at 2-1/2, 2-5/8, 3, 2-5/8 and 2-1/2 in, and each end (A, B) cut in with 1/2 in radius arcs, set in 1/4 in. Body part No. 2: 8-3/16 by 4-1/4 in, with fold lines at 2-19/32, 3 and 2-19/32 in. Lay each pattern on the leather and trim the leather even with it, guiding the knife with a metal straightedge, on a close-grained hardwood board or a piece of sheet zinc.

Матеріали для цього кроку:

Свиняча шкіраСвиняча шкіра1 штука
Картонні аркуші для шаблонівКартонні аркуші для шаблонів1 штука

Необхідні інструменти ({count})

ОлівецьОлівець
ЛінійкаЛінійка
Повірочна лінійкаПовірочна лінійка
Макетний ніжМакетний ніж
Дошка з твердої деревиниДошка з твердої деревини
Цинковий листЦинковий лист
4

Line the parts

Cut linings slightly larger than the patterns. Skiver is glued all over with a good, pliable leather glue that will not crack the leather; smooth it on gently without stretching, or the leather may buckle, and dry it under a light weight. Silk moire is glued with a thin stripe round the edges only, left to overhang, and trimmed off neatly when dry.

Матеріали для цього кроку:

Шовкова тканинаШовкова тканина1 штука
Клей для шкіриКлей для шкіри1 штука

Необхідні інструменти ({count})

НожиціНожиці
Макетний ніжМакетний ніж
5

Glue and fold

Fold part No. 1 to form the back and the two card pockets. Apply stripes of glue as shown in Fig. 3, drop part No. 2 (the money compartment) into place, and fold the ends of No. 1 over on the dotted lines. Weight the billfold and let the glue dry.

Матеріали для цього кроку:

Клей для шкіриКлей для шкіри1 штука

Необхідні інструменти ({count})

Модельєр для шкіриМодельєр для шкіри
6

Mark and punch the stitching

Draw a straight line with a blunt-point tool along the edges to be sewn, 3/16 in from them. Mark the stitch spacing for an inch on a strip of paper and transfer it along the line. Punch the holes on a pine board with a diamond-pointed awl held vertical (D); back the open ends with strips of cardboard while punching.

Необхідні інструменти ({count})

Модельєр для шкіриМодельєр для шкіри
ЛінійкаЛінійка
Шевське шило для підошвиШевське шило для підошви
Соснова дошкаСоснова дошка
Картонні аркуші для шаблонівКартонні аркуші для шаблонів
7

Sew and finish the edges

Sew with heavy waxed silk matching the leather, by hand or with the work clamped between two boards. Thread a needle on each end, start both from the right side (E), pass the needle from the first hole through the second (F) and, with the needles in position (G), continue this stitch. Tie the ends neatly. Trim the edges and tool them smooth with a suitable metal tool or rod, heated moderately, applying water with the fingertip.

Матеріали для цього кроку:

Шовкова ниткаШовкова нитка1 штука
Бджолиний віскБджолиний віск1 штука

Необхідні інструменти ({count})

Дві лимарські голкиДві лимарські голки
НожиціНожиці
Макетний ніжМакетний ніж
Круглий пруток з маловуглецевої сталіКруглий пруток з маловуглецевої сталі
8

Troubleshooting

Billfold troubleshooting.

Flow

Loading...
9

History and honest limits

From "A Craftsman Leather Billfold" by Livingston Haviland, in **The Boy Mechanic, Book 3**, Popular Mechanics, 1919 (Project Gutenberg 71856; checked on the archive.org scan boymechanic0003unse, pp. 446-447). He does not give the number of stitches to the inch or what waxes the silk (beeswax is ours). Pigskin is one of his four leathers. The tools and metric figures are ours.

Матеріали

6

Необхідні інструменти

13

За цим кресленням виготовляють

CC0 Суспільне надбання

Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.

Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.

Обговорення

(0)

Увійти щоб приєднатися до обговорення

Завантаження коментарів...