Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)
Tex

Criado por

Tex

13. novembro 2026FO
5
0
0
0
0

Saddle Breastplate: Rounded Side Straps, Neck Strap and Girth Strap on Covered Rings (Hasluck, Saddlery, 1904)

A breastplate stops a riding saddle sliding backwards, as a crupper stops it sliding forwards. This is the hunting saddle breastplate from Paul N. Hasluck's Saddlery (1904): two rounded side straps from the shoulders to a ring at the chest, a cross strap over the neck, two small buckle straps to the saddle staples, and a strap between the forelegs to the girth. Every size is his.
Avançado
About 1 day

Instruções

1

His sizes in centimetres

A carregar o notebook Jupyter…
2

Read Saddlery, ch. V

"Breastplates (Fig. 10) are made for hunting saddles to prevent them falling backwards, just as the crupper keeps them from advancing too far."
3

Get the rings and buckles

You need one 1-1/2 in covered ring, two 1 in covered rings, two 5/8 in covered buckles and one 1 in covered buckle.

Materiais para este passo:

Argola forradaArgola forrada3 peças
Fivela forradaFivela forrada3 peças

Ferramentas necessárias:

Fita métricaFita métrica
4

Make the two side straps

Cut two side straps 7/8 in wide and 2 ft long when turned over the rings at each end. Round the top on the groove board, stuffing it with strands of soft cord. Stitch them along both sides very finely with silk cotton or linen thread, putting a 1 in ring at one end of each and both other ends into the 1-1/2 in ring. Polish the edges well after stitching.

Materiais para este passo:

Couro para arreiosCouro para arreios1 peça
CordelCordel1 peça
Fio de linhoFio de linho1 peça
Cera de abelhaCera de abelha1 peça
Argola forradaArgola forrada3 peças

Ferramentas necessárias:

Faca para couroFaca para couro
Tábua de ranhurasTábua de ranhuras
SovelaSovela
Duas agulhas de correeiroDuas agulhas de correeiro
Torno de seleiroTorno de seleiro
Brunidor de bordos de couroBrunidor de bordos de couro
Fita métricaFita métrica
5

Make the cross strap

Cut a 1-3/8 in strap to be 10 in long when bent over the rings at each end; shave the ends and prick the sides finely like the shoulder piece. Cut another piece 9-1/4 in long when bent for the rings, 7/8 in wide at both ends and widening gradually to 1-3/4 in in the centre. Put the chapes in the 1 in rings and stitch both pieces together.

Materiais para este passo:

Couro para arreiosCouro para arreios1 peça
Fio de linhoFio de linho1 peça
Cera de abelhaCera de abelha1 peça

Ferramentas necessárias:

Faca para couroFaca para couro
Vazador de costuraVazador de costura
SovelaSovela
Duas agulhas de correeiroDuas agulhas de correeiro
Torno de seleiroTorno de seleiro
Fita métricaFita métrica
6

Make the two buckle straps

Make two 5/8 in straps 2 ft long, one end prepared for the buckle, the other narrowed; edge, rub and crease them with a hot checker. Put one in each 1 in ring to within 3 in of the buckle. Double the 3 in length with the buckle on top and make two loops between the two leathers. Stitch from the ring along both sides to the buckle, fastening the loops at the same time. Finish the edges of the stitched part and make seven or eight holes in the points.

Materiais para este passo:

Couro para arreiosCouro para arreios1 peça
Fivela forradaFivela forrada2 peças
Fio de linhoFio de linho1 peça
Cera de abelhaCera de abelha1 peça

Ferramentas necessárias:

Faca para couroFaca para couro
Biselador de bordosBiselador de bordos
Brunidor de bordos de couroBrunidor de bordos de couro
DobradeiraDobradeira
Maçarico a propanoMaçarico a propano
Forma de passadoresForma de passadores
SovelaSovela
Duas agulhas de correeiroDuas agulhas de correeiro
Vazador para couroVazador para couro
7

Make the girth strap

Cut a strap 1-1/4 in wide and 3 ft long. Narrow it to 1 in at 1 ft from the bend at the ring and turn it down for the 1 in buckle at the narrow end; edge, rub and crease it, then put the buckle in the reverse way. Cut eight or nine holes, beginning about 8 in from the buckle, and buckle the strap back on itself to make a loop for the girth (bellyband) to pass through.

Materiais para este passo:

Couro para arreiosCouro para arreios1 peça
Fivela forradaFivela forrada1 peça
Fio de linhoFio de linho1 peça
Cera de abelhaCera de abelha1 peça

Ferramentas necessárias:

Faca para couroFaca para couro
Biselador de bordosBiselador de bordos
Brunidor de bordos de couroBrunidor de bordos de couro
DobradeiraDobradeira
Maçarico a propanoMaçarico a propano
SovelaSovela
Duas agulhas de correeiroDuas agulhas de correeiro
Vazador para couroVazador para couro
8

Fit the safe

Put the other end of the girth strap in the 1-1/2 in ring. Cut a safe to go under it, running up under the ring round the top part and down about 3-1/2 in below the bend, narrowing towards the end almost to the width of the strap. Crease the safe and place it under the chape and ring; stitch it down on both sides with a fancy stitch in the centre. Line the safe with chamois or very thin buff, stitched in all round, stuff a little flock through the opening at the bottom, and close the opening with fancy stitching such as an arrow point. He adds that it can be made of single leather without lining, only the bends being stitched.

Materiais para este passo:

Couro para arreiosCouro para arreios1 peça
CamurçaCamurça1 peça
Enchimento de lãEnchimento de lã1 peça
Fio de linhoFio de linho1 peça
Cera de abelhaCera de abelha1 peça

Ferramentas necessárias:

Faca para couroFaca para couro
DobradeiraDobradeira
Maçarico a propanoMaçarico a propano
SovelaSovela
Duas agulhas de correeiroDuas agulhas de correeiro
Torno de seleiroTorno de seleiro
9

Put it on the horse

The long side straps run down from the shoulder to the chest, and the short cross strap passes over the neck at the top. The two small straps buckle to the staples in front of the saddle, and the girth strap runs from the big ring under the belly between the forelegs to the girth.
10

Troubleshooting

Breastplate troubleshooting.

Flow

Loading...
11

History and honest limits

From **Saddlery**, edited by Paul N. Hasluck, David McKay, 1904 (archive.org saddlery00hasl), chapter V, "Saddle Cruppers, Breastplates, and Other Accessories", breastplates, pp. 41-44, Fig. 10; every fraction was read on the scan. He says the cross strap is pricked "like the shoulder piece" without describing a shoulder piece; check the cross strap against Fig. 10. The crupper, martingale, girths, stirrup leathers and saddle cloths of the same chapter are not made here. The tools and metric figures are ours.

Materiais

8

Ferramentas necessárias

13

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...