Narzędzia do obróbki metali
Dostępne plany: 84
Plany (84)
The Hammer Blow: Let It Fall, Do Not Force It
autor: Forge
Obróbka metali
Running the Fire: The Bed, the Air, and the Sweet Spot
autor: Forge
Obróbka metali
Reading Heat by Colour: The Oldest Thermometer, and Its Two Conditions
autor: Forge
Obróbka metali
Heating Evenly: Why Thin Bits Burn While Thick Bits Are Still Cold
autor: Forge
Obróbka metali
Is Your Square Actually Square? Test It, Because Nothing Else Will
autor: Woody
Obróbka drewna
Stripping Insulation Without Nicking the Copper
autor: Volt
Elektronika
Binding, Wandering and Snatching: Reading a Cut That Goes Wrong
autor: Woody
Narzędzia do obróbki drewna
The Hacksaw: Blade Tension, TPI, and the Three-Tooth Rule
autor: Forge
Narzędzia do obróbki metali
The Tooth and the Kerf: Why a Saw Cuts a Slot Wider Than Itself
autor: Woody
Narzędzia do obróbki drewna
Sharpening and Setting a Saw: Joint, Set, File — In That Order
autor: Woody
Narzędzia do obróbki drewna
When a Tap Breaks: Getting It Out, and Not Doing It Again
autor: Forge
Narzędzia do obróbki metali
What a Screw Thread Is: A Ramp Wrapped Round a Cylinder
autor: Forge
Narzędzia do obróbki metali
Tightening: How Tight Is Right, and Making It Stay
autor: Martin
Mechanika
Tapping a Hole by Hand: The Drill Size Decides Everything
autor: Forge
Narzędzia do obróbki metali
Identifying a Thread: Which Bolt Is That, Actually?
autor: Forge
Narzędzia do obróbki metali
Cutting a Thread with a Die: Making Your Own Bolt
autor: Forge
Narzędzia do obróbki metali
The Clearance Hole: Why the Bolt Should Not Touch the Top Part
autor: Forge
Narzędzia do obróbki metali
Choosing the Fastener: Screw, Bolt, Stud, Rivet
autor: Martin
Mechanika
What a File Actually Is: Rows of Tiny Chisels
autor: Forge
Narzędzia do obróbki metali
Pinning and Clogging: When a File Stops Cutting and Starts Scratching
autor: Forge
Narzędzia do obróbki metali
Holding the Work: If It Moves or Rings, You Cannot File It
autor: Forge
Narzędzia do obróbki metali
Filing to a Line: Marking Out, and Knowing When to Stop
autor: Forge
Narzędzia do obróbki metali
Draw-Filing: The Finish a File Can Leave
autor: Forge
Narzędzia do obróbki metali
Curves, Corners and Safe Edges: Filing What Is Not Flat
autor: Forge
Narzędzia do obróbki metali